AAMP of Florida AAMP Global ISBT32RB BluJax User Manual ISBT32R Manual 2018 1
AAMP of Florida, Inc. dba AAMP Global BluJax ISBT32R Manual 2018 1
user_manual
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested
and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.The device has been evaluated to meet general RF
exposure requirement. The device can be used in portable exposure condition without restriction.
Power save mode
If your smartphone is out of range for 5 minutes, BluJax will automatically turn off to preserve the battery power.
When returning to the vehicle, press the control button once to wake BluJax up.
You can expect about 8 hours of playback from BluJax on a single charge. When BluJax is low, it will flash
red, and say "Battery low, please charge.“
For Pairing Multiple Devices (BluJax can store up to 5 paired smartphones in its memory)
a. To pair an additional device, disconnect from the currently paired device by going into your
smartphone’s Bluetooth settings and clicking “Disconnect.”
b. BluJax can connect to 2 phones at the same time.
c. If you have more than 5 devices, the oldest paired device will be erased when you pair with a new
smartphone.
d. Follow intial pairing instructions.
In Case of Tight Quarters
The 3.5mm jack on BluJax has been intentionally designed to be off-center so that it can be rotated to
allow it to clear buttons or other obstructions located near your AUX input. If rotating BluJax is not
allowing full insertion into the AUX input, we have provided a short extension cable which can be used
to make the connection. Connect the extension cable between BluJax and the AUX input.
Battery Low
Tech Support:
support@isimplesolutions.com
866-788-4237
BluJ ax
INSTRUCTION MANUAL
BluJax - ISBT32 Rev B
FCC ID:XBD-ISBT32RB