ALPS ALPINE I61M0 Immobilizer base station User Manual 05

Alps Electric Co., Ltd. Immobilizer base station 05

05 User Manual

　The connector is arranged as shown in the figure below.Terminal No. I/O1I2I3 I/O4I5-6I7-8ISince this device is always used with vehicle, it is not sold to general end users separately.Therefore there is no user manual of this device by alone.The following should be displayed in the user manual of the vehicleThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.FCC CAUTIONChanges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.DC5～16VOperation of frequency 125kHzOperating voltage DC5～16V(Inner:DC 5V)Operating temperaturerange-40~＋85　degree CMAX 0.7mA(@12V 25℃) at standbyWeight 0.043kgConsumption currentspecMAX 150mA(@12V 25℃) at operationDC12VRange of voltageConsumption current Under 0.7mA（Standby current）W69xL63xH54（mm）SizeAC/DC SupplyUser ManualGND-LED　It communicates with IC used both as Transponder and Passive RKEthrough LF ANT(Z axis) of immobi-key, and operates as ANT to exchangecommunication data depending on community signal with BCM.　The immobilizer antenna communicates with the transponder in the immobi -key when the it is inserted, and receives the code of the key. The immobilizeris used with key cylinder by inserting the immobi-key as shown in figure.Product name : Immobilizer base stationType : I61M0Terminal NameLEDGSCISCLVCC-immobi-key immobilizer anntena with key cylinderkey cylinderimmobilizer anntena

Navigation menu