AOB ELECTRONICS ES-52061BT Wireless Bluetooth Speaker User Manual
SHENZHEN AOB ELECTRONICS CO.,LTD Wireless Bluetooth Speaker
User Manual
Wireless Bluetooth Speaker
SHENZHEN AOB ELECTRONICS CO.,LTD
ES-52061BT
Wireless Bluetooth Speaker
Your speaker uses rechargeable battery. Fully charge
Charging time: Approximately 4hrs. Turn your speaker
more than 10 minutes. Switch your speaker off and
Before using the speaker, please pair it with your
Turn the speaker ON. Speaker will automatically
Set your Bluetooth to discover the speaker by
FOR NEW DEVICE. Click on speaker when it
speaker, press "OK" to pair with the speaker.
Once successfully paired, the speaker
CHARGING YOUR SPEAKER PAIRING DEVICE WITH YOUR SPEAKER
your Bluetooth-enabled smartphone. Press “ ” to answer call;
Press “ ” to end call.
. For best call quality, make sure you are
Wireless Bluetooth Speaker
Bluetooth-enabled device. You can use the speaker
the speaker can not increase the volume higher than
The speaker can only pair to one device at a
facing the speaker and within 3 feet/1 meter.
speaker can not increase the volume higher than the
would still like to use with the speaker. The
Turn the speaker ON and plug the 3.5mm audio
If Bluetooth-enabled device fails to locate the speaker,
Restart your speaker to reactivate Bluetooth pairing
any other Bluetooth device as the speaker can only FCC Warning:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
---Reorient or relocate the receiving antenna.
---Increase the separation between the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
---Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not
explicitly approved by manufacturer could void your authority to
operate this equipment.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.