ARCHETYPE SNL Pathlights User Manual PathLights Catalog 2012
ARCHETYPE LTD. Pathlights PathLights Catalog 2012
user manual
With the new easy-to-install PathLights lighting system, your path will automatically light up under
low-light conditions. Using our Instant Lit technology, “A” light units alert “B” light units to turn on
immediately lighting your way with a warm glow that brightens your path. The lights remain on for
approximately one minute, giving you the time you need to walk up or down stairs or a dark hallway,
and then turn off automatically. Nothing could be simpler.
PathLights can be mounted onto any wall surface using the included double-stick tape or screws. It
takes less than 5 minutes to install the three lights in this package. For interior use only.
How do PathLights work?
Where can I put my PathLights?
PathLights are designed to work only under low-light conditions - they do not turn on unless it’s dark.
The UNITS sense the light level in the room. Motion detection is only activated when it’s dark.
Motion detecting UNITS activate UNITS within 18 feet of the UNITS and automatically lights your way.
Staircases
Hallways
PathLights work under
low-light conditions only.
The 3 PathLights function
as a system - not designed
to work as individual units.
PathLights stay on for
about one-minute and
then turn off automatically.
Distributed by
Short Hills, NJ
ARCHETYPE
Patent Pending
All Rights Reserved
Made in China
™
1Find the 3 plastic mounting plates (back
of units) in the package.
Determine where you want to place
your PathLights. Refer to “Where
can I put my PathLights?” above
as a guide.
2Attach the mounting plates to the wall - about 8
inches to 10 inches from the floor - using either the
enclosed screws or the attached double-stick tape.
Make sure that the mounting plate is oriented
correctly -- the words “LEVEL LINE” on the
mounting plate should be horizontal and readable.
3
4Rotate each unit clockwise onto a
mounting plate until it comes to a stop.
Your Pathlights are ready for use.
Questions? Call us at 1-866-797-6686
LEVEL LINE
Mounting PathLights to the Wall
8”-10” from
floor/step
to bottom of
PathLight
Insert 3 “AA” batteries into each unit
as indicated in battery compartment.
FCC Statement:
This equipment has been tested and found to comply with the limits for Part 15 of
the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: Modifications to this product will void the user’s authority to operate
this equipment.