ARRIS 2402GCT MG2402G/CT ARRIS Media Gateway Box User Manual 12 0437 Exhibit Cover
ARRIS Group, Inc. MG2402G/CT ARRIS Media Gateway Box 12 0437 Exhibit Cover
ARRIS >
Manual
Certification Exhibit FCC ID: UID2402GCT IC: 6670A-2402GCT FCC Rule Part: 15.247 IC Radio Standards Specification: RSS-210 ACS Project Number: 12-0437 Manufacturer: Arris International, Inc. Model: MG2402G/CT Manual 5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598 Touchstone® MG2402G/CT Media Gateway User’s Guide The Touchstone MG2402G/CT Media Gateway enables all TV and DVR, telephony and data service in the home, through Hybrid Fiber Coax (HFC) access network using DOCSIS RF interface standards. Whether you’re watching TV, checking out streaming media, downloading new software, checking your email, or talking with friends on the phone, the Touchstone MG2402G/CT Media Gateway brings it all to you faster and more reliably, all while providing toll quality Voice over IP telephone service and both wired and wireless connectivity. It also provides a Lithium-Ion battery backup to provide continued telephone service during power outages. The Touchstone Media Gateway provides four Ethernet connections for use as the hub of your home/office Local Area Network (LAN). The Media Gateway also provides dual band 2.4 GHz 802.11b/g/n and 5 GHz 802.11a/n wireless connectivity for enhanced mobility and versatility. In addition, the Media Gateway provides for up to two separate lines of telephone service and a DECT 6.0 (United States DECT) base station interface. The Media Gateway also offers integrated MoCA 2.0 home networking providing Internet access and transfer of multimedia content between devices over coaxial cable in the home. Installation is simple and your cable company will provide assistance to you for any special requirements. The links below provide more detailed instructions. Export Regulations This product may not be exported outside the U.S. and Canada without U.S. Department of Commerce, Bureau of Export Administration authorization. Any export or re-export by the purchaser, directly or indirectly, in contravention of U.S. Export Administration Regulation is prohibited. Copyright © 2013 ARRIS. All rights reserved. The information in this document is subject to change without notice. The statements, configurations, technical data, and recommendations in this document are believed to be accurate and reliable, but are presented without express or implied warranty. Users must take full responsibility for their applications of any products specified in this document. The information in this document is proprietary to ARRIS. ARRIS, Touchstone, and the ARRIS logo are trademarks or registered trademarks of ARRIS Group. All other trademarks and registered trademarks are the property of their respective holders. Protected under one or more of the following U.S. patents: 7,031,435. Other patents pending. Release 24 Draft 1.1 May 2013 Safety Requirements ARRIS Media Gateways comply with the applicable requirements for performance, construction, labeling, and information when used as outlined below: CAUTION Risk of shock Mains voltages inside this unit. No user serviceable parts inside. Refer service to qualified personnel only! CAUTION Potential equipment damage Potential loss of service Connecting the Media Gateway to existing telephone wiring should only be performed by a professional installer. Physical connections to the previous telephone provider must be removed and the wiring must be checked; there must not be any voltages. Cancellation of telephone service is not adequate. Failure to do so may result in loss of service and/or permanent damage to the Media Gateway. CAUTION Risk of explosion Replacing the battery with an incorrect type, heating a battery above 75°C, or incinerating a battery, can cause product failure and a risk of fire or battery explosion. Do not dispose of in fire. Recycle or dispose of used batteries responsibly and in accordance with local ordinances. • The Media Gateway is designed to be connected directly to a telephone. • Connecting the Media Gateway to the home’s existing telephone wiring should only be performed by a professional installer. • Do not use product near water (i.e. wet basement, bathtub, sink or near a swimming pool, etc.), to avoid risk of electrocution. Touchstone MG2402G/CT Media Gateway User’s Guide • Do not use the telephone to report a gas leak in the vicinity of the leak. • The product shall be cleaned using only a damp, lint-free, cloth. No solvents or cleaning agents shall be used. • Do not use spray cleaners or aerosols on the gateway. • Avoid using and/or connecting the equipment during an electrical storm, to avoid risk of electrocution. • Do not locate the equipment within 6 feet (1.9 m) of a flame or ignition source (i.e. heat registers, space heaters, fireplaces, etc.). • Use only power supply and power cord included with the equipment. • Equipment should be installed near the power outlet and should be easily accessible. • The shield of the coaxial cable must be connected to earth (grounded) at the entrance to the building in accordance with applicable national electrical installation codes. In the U.S., this is required by NFPA 70 (National Electrical Code) Article 820. In the European Union and in certain other countries, CATV installation equipotential bonding requirements are specified in IEC 60728-11, Cable networks for television signals, sound signals and interactive services, Part 11: Safety. This equipment is intended to be installed in accordance with the requirements of IEC 60728-11 for safe operation. If the equipment is to be installed in an area serviced by an IT power line network, as is found in many areas of Norway, special attention should be given that the installation is in accordance with IEC 60728-11, in particular Annex B and Figure B.4. • In areas of high surge events or poor grounding situations and areas prone to lightning strikes, additional surge protection may be required (i.e. PF11VNT3 from American Power Conversion) on the AC, RF, Ethernet and Phone lines. • When the Media Gateway is connected to a local computer through Ethernet cables, the computer must be properly grounded to the building/residence AC ground network. All plug-in cards within the computer must be properly installed and grounded to the computer frame per the manufacturer’s specifications. • Ensure proper ventillation. Position the Media Gateway so that air flows freely around it and the ventillation holes on the unit are not blocked. Touchstone MG2402G/CT Media Gateway User’s Guide • Do not mount the Media Gateway on surfaces that are sensitive to heat and/or which may be damaged by the heat generated by the modem, its power supply, or other accessories. FCC Part 15 This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. RF Exposure This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 7.9 inches (20cm) between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Touchstone MG2402G/CT Media Gateway User’s Guide Industry Canada Compliance Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. For Mexico The operation of this equipment is subject to the following two conditions: (1) This equipment or device cannot cause harmful interference and (2) this equipment or device must accept any interference, including interference that may cause some unwanted operation of the equipment. Touchstone MG2402G/CT Media Gateway User’s Guide Touchstone® MG2402G/CT Media Gateway User’s Guide Copyright © 2013 ARRIS. All rights reserved. The information in this document is subject to change without notice. The statements, configurations, technical data, and recommendations in this document are believed to be accurate and reliable, but are presented without express or implied warranty. Users must take full responsibility for their applications of any products specified in this document. The information in this document is proprietary to ARRIS. ARRIS, Touchstone, and the ARRIS logo are trademarks or registered trademarks of ARRIS Group. All other trademarks and registered trademarks are the property of their respective holders. Protected under one or more of the following U.S. patents: 7,031,435. Other patents pending. Release 24 Draft 1.1 May 2013
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes Page Count : 8 XMP Toolkit : 3.1-701 Producer : ScanSoft PDF Create! 7 Keywords : Telephony Gateway Creator Tool : Microsoft Word - 12-0437 - Exhibit Cover.doc Create Date : 2013:05:21 08:07:50-04:00 Modify Date : 2013:05:21 08:07:51-04:00 Title : Microsoft Word - 12-0437 - Exhibit Cover.doc Creator : courtney.mcgann Description : MG2402G/CT Installation, Configuration, Operation, Troubleshooting Author : courtney.mcgann Subject : MG2402G/CT Installation, Configuration, Operation, TroubleshootingEXIF Metadata provided by EXIF.tools