ASSALOY YRHCPZB0FM Zigbee Transceiver Module User Manual 1

Download:
Mirror Download [FCC.gov]
Document ID	2641909
Application ID	IsO3DO7q0AgIG8f24DjGvQ==
Document Description	User manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	71.04kB (887959 bits)
Date Submitted	2015-06-09 00:00:00
Date Available	2015-06-10 00:00:00
Creation Date	2017-09-29 20:07:41
Producing Software	GPL Ghostscript 9.18
Document Lastmod	2017-09-29 20:07:41
Document Title	Untitled-1
Document Creator	CorelDRAW X6
Document Author:	Kim

®
Yale Real Living™ ZigBee Module
Installation and Programming Instructions
Installing the ZigBee® Module
IMPORTANT: the batteries must be removed prior
to removing and/or inserting the network module:
• Remove battery cover.
• Remove batteries.
• Remove and/or insert network module.
• Reinstall batteries.
• Replace cover.
Enrolling/Unenrolling the Network Module:
It is recommended that lock is programmed through the centralized user interface (PC or
hand-held device) to ensure communication between the lock and the controller unit. The
network controller first needs to be in enrollment or exclusion mode for the lock to be
enrolled or unenrolled from network.
To Enroll the Module:
• Enter the 4-8 digit Master PIN code followed by the
• Press the
key followed by the
key.
• Press the
key followed by the
key.
To Unenroll the Module:
• Enter the 4-8 digit Master PIN code followed by the
• Press the
key followed by the
key.
• Press the
key followed by the
key.
key.
key.
P/N AYR200-ZB-INSTAL-FUL Rev E
FCC:
FCC ID: UA4-YRHCPZB0FM
Model: YRMZB2
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful Interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Any changes or modifications not expressly approved by manufacturer could void the user’s authority to
operate the equipment.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate this equipment.
Industry Canada:
IC: 6982A-YRHCPZB0FM
Model: YRMZB2
Section 8.4 of RSS-GEN This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the
following two conditions: 1) this device may not cause interference, and 2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement.
Important Note:
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator and your body.
Note Importante: (Pour l’utilisation de dispositifs mobiles)
Declaration d’exposition aus radiations:
Cet équipement est conforme aux limites d´exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet
équipment doit être installé et utilisé avec un mimimum de 20 cm de distance entre la source de rayonnement et votre corps.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate this equipment.
IMPORTANT! Tous les changements ou modifications pas expressément approuvés par la partie responsable de la conformité ont
pu vider l’autorité de l’utilisateur pour actioner cet équipment.
Product Support Tel 800.810.WIRE (9473) • www.yalelocks.com
Yale Locks & Hardware is a division of Yale Security Inc., an ASSA ABLOY Group company.
Yale® is a registered trademark of Yale Security Inc., an ASSA ABLOY Group company.
Yale Real Living™ is a trademark of Yale Security Inc., an ASSA ABLOY Group company.
Copyright © 2015, Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
YALE, with its unique global reach and range of products, is the world's favorite lock
– the preferred solution for securing your home, family and personal belongings.
ASSA ABLOY is the global leader in door opening solutions,
dedicated to satisfying end-user needs for security, safety and convenience.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract, Print high-res
Author                          : Kim
Create Date                     : 2015:05:12 08:44:40-04:00
Modify Date                     : 2015:05:12 11:55:42-06:00
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Format                          : application/pdf
Creator                         : Kim
Title                           : Untitled-1
Creator Tool                    : CorelDRAW X6
Metadata Date                   : 2015:05:12 11:55:42-06:00
Producer                        : Corel PDF Engine Version 16.1.0.843
Document ID                     : uuid:f8d99be8-4967-4113-b6ea-0ba42628053d
Instance ID                     : uuid:3ac46405-43da-47ec-894d-6ab2deb830e7
Page Count                      : 2

EXIF Metadata provided by EXIF.tools