ASTEELFLASH FRANCE ARVAADV4 Low Power Transmitter Below 1705 kHz User Manual EN O9BARVAADV4

ASTEELFLASH FRANCE Low Power Transmitter Below 1705 kHz EN O9BARVAADV4

Contents

User manual EN - O9BARVAADV4.pdf

EVO 4
100% digital
USER MANUAL
CDF15EFR
• 100% digital
TECHNICAL FEATURES5-YEAR WARRANTY FOR THIS DEVICE
REGISTER YOUR DEVICE ON WWW.ARVA-EQUIPMENT.COM
R&TTE Declarations of Conformity
Hereby. Name of manufacturer: AsteelFlash France. Adress: 43, rue du Vieux
Chêne. Zip Code: 38240. City: Meylan. Country: France. Declares that the ava-
lanche beacon. Type designation: EVO4. Trademark: ARVA, is in compliance with
the essential requirements and other relevant provisions of directive. 1999/5/EC.
The compliance of the device has been evaluated according to the Electromagnetic
compatibility standard test: FCC CFR 47 part 15, Subpart C. The complete decla-
ration of conformity is available at the address above. Name: TORRES. Fonction:
Establishment Development Director. Date: 19/08/2011. Signature:
FCC requirements: - FCC ID: O9BARVAADV4
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protec-
tion against harmful interference in a residential
installation. This equipment generates uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the instruc-
tion, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular in-
stallation. If this equipment does cause harmful
interference to radio or television reception which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
Disposal of electronic instruments by users from private house-
holds in the European Union. This symbol stamped on the product or its
packaging indicates that the product is not allowed to be disposed of with
household waste. It is your responsibility to bring your electronics waste
to a designated recycling ofce for proper disposal. Separate disposal and
recycling of your waste will contribute to preserving our natural resources
and ensure an environmentally-friendly disposal safer for public health.
For more information regarding the closest recycling center to your res-
idence, contact your local city hall, waste management company, or the
store where you purchased the product.
The V-shaped conveyor
technique allows you to
optimize the excavation
phase of shoveling. As soon
as the person is uncovered,
it is important to turn their
transceiver off immediately.
Search for the victim
by probing in concentric
spirals progressively
away from the minimum
distance point detected
by your ARVA. Probe
perpendicular to the
slope.
IN SEARCH MODE :
Move all metallic and electronic devices at least 50cm away
from your transceiver.
During an active search, we recommended turning off all
devices except :
• Analog radio
• Headlamp without dimmer
• Watch without a radio function
• Backup devices in the event of a secondary avalanche
Means of communication :
We recommend turning off all digital telephones and radios
during the active search phase. All calls should be made at
least 25m away from the individuals conducting the active
search.
IN TRANSMIT MODE :
Move all metallic and electronic devices at least 20cm away
from your transceiver.
Certain electronic devices as well as electrical and electromag-
netic installations can signicantly interfere with transceiver
signals.
These sources are :
• carried: smart phone - analog radio - camera - heart rate
monitors - GPS - etc.
• permanent: relay towers - power lines / electrical generating
equipment - ski lifts, etc.
In order to reduce the risk of signal deterioration, we recom-
mend that you keep your transceiver as far as possible from
sources of electrical and electromagnetic activity.
Statistically, shoveling takes at least as much time as
the ARVA search. It is important to take a methodic approach
to shoveling.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
MULTIPLE BURIAL INDICATOR
SHOVELING
PROBING INTERFERENCE
MARKING FUNCTION
• 3 antennas
SEARCH/
TRANSMIT
BUTTON
MARKED
VICTIM
BUTTON
ON/ OFF
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equip-
ment and receiver.
- Connect the equipment into an outlet on cir-
cuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/ TV
technician for help.
- Information to user: Changes or modications
not expressly approved by the party responsible
for compliance could void the user’s authority to
operate the equipment.
UNMARKED VICTIM
MARKED VICTIM
90°
25
cm
25
cm
To mark the victim, press on the
“marking” button. The device will
switch to victim B.
When you are less
than 3m from the rst
victim you have the
option of marking the
location in order to
continue searching for
another signal. In the
illustration example,
you can mark victim A.
A
B
• Distance and direction indicator
• Marking function for multiple burials
• An icon for 1, 2, 3 or more victims
• 40m search bandwidth
• 220 g
• Battery life: 250+ hours
• Requires 4 alkaline AAA/ LR06 batteries
• Group check
4 OR MORE BURIALS
DEVICE USE INSTRUCTIONS INITIAL START-UP GROUP CHECK
SWITCHING TO SEARCH MODE
SIGNAL SEARCH COARSE SEARCH FINE SEARCH
INSERTING BATTERIES AND RECOMMENDATIONS.
The ARVA EVO4 only operates with 4 standard Alkaline
AAA/ LRO3 batteries. Open the compartment on the back
of the device to insert the 4 batteries. The 4 batteries should
always be from the same brand and replaced at the same time.
BATTERY CHECK
Just after turning on your device,
it will indicate the battery level.
We recommend that you replace
the batteries as soon as they drop
below 50%.
Start searching for a signal based on one of the two
diagrams below.
During the coarse search.
• Carefully follow the distance and direction indicators
on the screen
• Point the device in the direction of the signal
Once within 3 meters of the victim, your ARVA no longer
indicates a direction and you must start bracketing
(searching in a cross pattern).
• In a complex situation with multiple victims, the device
may have trouble analyzing the signal. In this case, move
a few steps away and then return towards the critical point
by following another direction.
DURING THE SEARCH, PAY ATTENTION TO VISUAL CLUES
SUCH AS POLES, SKIS, CLOTHING, ETC.
It is then much quicker to start probing once you have
dened the probable burial zone within a less than
one-meter range
Example of
ne search
technique
• Search in a calm and
focused manner
• Slow down as you
approach the ne search
• If the displayed distance
starts to increase even
though you are moving in
the direction indicated by
the arrow, turn around
1. Lower your device to
near snow level
2. Move your device in a
cross pattern to locate the
point where the distance
reading is the lowest
To maximize the range of your ARVA :
SEARCH MODE
To switch to search mode, push the
S/T button up with your thumb.
“CLIP FOR SAFE”
Once you are wearing your
transceiver, it automatically turns
on as soon as you connect the strap.
This is a simple and easy way to
be 100% certain that your ARVA
is working as soon as you start
your outing. For more advance
users (professionals) who do not
want to use the clip for safe feature,
a special holster is available for
purchase as an accessory.
LABEL FOR PRODUCT SERVICE
A sticker indicating the unique reference number for your
device and the warranty date is located inside the battery
compartment. Please leave this sticker in place in order to
properly service the device.
PRACTICE AS MUCH AS POSSIBLE: MORE IMPORTANT
THAN THE PERFORMANCE CAPABILITIES OF YOUR ARVA,
KNOWING YOUR DEVICE WILL MAKE ALL THE DIFFERENCE.
TAKE THE TIME AT THE BEGINNING OR END OF THE SEASON
TO SEND YOUR ARVA IN FOR MAINTENANCE.
It is important to point your
ARVA in the direction of
the avalanche, parallel to
the slope and not pointing
upwards towards the sky.
Slowly rotate back and forth
to try to detect the signal(s).
• The Group Check function
allows the group leader to verify
that all other transceivers are
working properly
• To enter Group Check mode,
press the marking button within
5 seconds after turning on the
device (in transmit mode)
• The device will verify all
transmitting signals within a 0.5
to 1.5 meter radius, and emit
a beep to conrm that they function
properly
• To exit Group Check mode, press
the marking button
NEVER USE RECHARGEABLE OR LITHIUM BATTERIES.
WEARING THE DEVICE
Your ARVA must always be worn on
top of your base layer. Your ARVA
should always be covered by at least
one layer of clothing to protect it
from the cold and impacts.
•
1st probing
point
These batteries lose their charge all of a sudden and do not
discharge gradually. Remove the batteries when the device is
not in use for long periods of time (especially in summer). If the
batteries leak inside the device, the warranty no longer applies.
CAUTION: THERE IS A RISK OF EXPLOSION IF THE BATTERY
IS THROWN INTO A FIRE OR REPLACED BY THE WRONG TYPE
OF BATTERY. FOLLOW INSTRUCTIONS ON HOW TO PROPERLY
DISPOSE OF USED BATTERIES.
IMPORTANT FOR SWITZERLAND: APPENDIX 4.10 FOR
STANDARD SR 814.013 APPLIES TO BATTERIES.

Navigation menu