ATTOWAVE RL-RCU REMOTE RADAR User Manual Appendix H RL360
ATTOWAVE CO., LTD. REMOTE RADAR Appendix H RL360
ATTOWAVE >
User Manual
RCU Operation Manual
1. MUTE Button
Press and release MUTE button to turn off the audio for any alert. When an
audio alert is sounded, you can silence the alarm by pressing MUTE button.
Press MUTE button again to turn on the audio alert.
2. Mark Button
Press and release MARK button to memory the location you have selected.
This location is stored in the memory and give an audio alert when you pass
the marked location.
3. Volume Up Button
Press Volume Up button to increase the audio volume.
4. Volume Down Button
Press Volume down button to decrease the audio volume.
5. CITY/HIGHWAY Button
City mode reduces the annoyance of false alerts typically encountered in
urban driving areas.
Highway mode provides full audio warning any time radar(X, K, Ka) or
laser signals are detected, and is recommended for open road driving.
6. Power Button
Press and release the POWER button to turn the unit on or off.
INSTALLATION
Mounting Guidelines
• Mount the RCU near the driver’s seat or host board.
• Do not mount your unit behind any objects. These obstructions have metal
surfaces which can affect communication with host board.
• To reduce the possibility of theft, conceal your unit when not in use.
• Make sure the mounting location you have chosen is relatively level and is clean
and dry. Clean with isopropyl alcohol if necessary to remove any waxes or
polishes.
• Separate the fastener strips. Peel the paper backing off each strip and adhere
one piece to the place and the other piece to the bottom of the unit.
Battery Replacement
The battery is equipped with the unit. To replace the battery, carefully open the
battery door.
LIMITED WARRANTY
The manufacturer warrants this product against all defects in materials and
workmanship for a period of one (1) year from the date of the original purchase, subject
to the following terms and conditions: The sole responsibility of the manufacturer under
this Warranty is limited to either repair or, at the option of the manufacturer,
replacement of the unit. There are no expressed or implied warranties, including those
of fitness for a particular purpose of merchantability, which extend beyond the face
hereof.
SPECIFICATIONS
Carrier Frequencies: 433.92 MHz (Single Channel)
Frequency Stabilization Scheme : High-Q SAW Resonator Stabilization
Modulation Method : Amplitude Shift Keying (By Carrier ON/OFF)
Bit Duration : “1” – 2.25msec / “0” – 1.125msec
Operating Temperature Range: -10° C to +80° C
Storage Temperature Range: -20° C to +90° C
Power Requirements: 3 V CR2032-type Li-Battery
FCC INFORMATION
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.