AUREL Spa 058402 RF SAW Transmitter User Manual

AUREL Spa RF SAW Transmitter

User Manual

TX3750-1C/2C/4C-SAW 434 Owner’s Manual RF SAW Transmitter with UM3750 Encoder RF transmitter with SAW resonator, up to 4 channels. It is ideal for applications where codified controls, high efficiency and low extraneous emissions are required. Available Models TX3750-1C-SAW 434: 1 p/button transmitter TX3750-2C-SAW 434: 2 p/buttons transmitterTX3750-4C-SAW 434: 4 p/buttons transmitterHow to use By pressing and releasing any of the provided push buttons (according to model) the code will be transmitted on the related channel. Channel 1 p/button Channel 3 p/button Channel 4 p/button Data transmissionLED Channel 2 p/button Full kitTX3750-4C-SAW 434 Model Battery replacement When the transmission LED light intensity is reduced, the supplying battery needs to be replaced. To this purpose loose the screw in the back side of the radiocontrol, and then carefully open the plastic shell. Once the old battery is removed, fit the new one (V23A, 12 V model) paying very much attention not to invert the polarity. Close back the transmitter’s plastic shell paying attention not to damage the integrated circuit. Please do not waste the old battery in the environment but place it inside the containers provided at this purpose, for its proper and correct disposal. Positive pole [+] Negative pole [-]AUREL shall not be deemed liable if product and related information are changed without notice. The Buyer shall be the sole responsible of the device use. AUR°EL S.p.A. Via Foro dei Tigli, 4 - 47015 Modigliana (FC) – ITALY Rev. B, July 17th 2003 Tel.: +390546941124 – Fax: +390546941660 Pag 1 of 2 http://www.aurel.it - e-mail: aurel@aurel.it
TX3750-1C/2C/4C-SAW 434 Owner’s Manual EC Reference Inside the front half shell of the transmitter plastic container, there is a label which contains the device’s identification data (product’s name, manufacturer, feed voltage and power consumption). [Internal] [External]Inside Outside Technical features Min Typical Max Unity Carrier’s frequency 433.92 ± 0.15 MHz Radiated power (E.R.P.) 0 dBm Modulation OOK (On Off Keying) Power consumption 7 15 mA Operating temperature -10 +55 °C Dimensions 75 x 43.5 x 18.5 mm Regulations compliance TX3750-1C-SAW 434, TX3750-2C-SAW 434 and TX3750-4C-SAW 434 transmitters comply with European Regulations ETS 300-220, ETS 300-683 and EN 60950. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Notice to user 1. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. The technical reports have been issued by the laboratory of the Company : PRIMA RICERCA & SVILUPPO – via Campagna, 58 – 22020 Gaggino Faloppio (CO) - Italy. AUREL shall not be deemed liable if product and related information are changed without notice. The Buyer shall be the sole responsible of the device use. AUR°EL S.p.A. Via Foro dei Tigli, 4 - 47015 Modigliana (FC) – ITALY Rev. B, July 17th 2003 Tel.: +390546941124 – Fax: +390546941660 Pag 2 of 2 http://www.aurel.it - email: aurel@aurel.it

Navigation menu