AVWOO TECHNOLOGY A023 Portable waterproof Speaker User Manual 2017 0322

SHENZHEN AVWOO TECHNOLOGY CO., LTD Portable waterproof Speaker 2017 0322

15_MMA3639 UserMan

SIZE: 70x158mmFCC NOTICE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer-ence to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ● Reorient or relocate the receiving antenna.   ● Increase the separation between the equipment and      receiver.    ● Connect the equipment into an outlet on a circuit      different from that to which the receiver is connected.   ● Consult the dealer or an experienced radio/TV      technician for help.FCC WARNING:To assure continued operation, follow the attached installation instructions and use only shield cables when connecting to other devices. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.                                                                1 POSSIBLE SOLUTIONRecharge the built-in battery as page 2.Increase the volume by press and holding the      ButtonRise the volume level of the paired/connected deviceReduce the volume level by press and holding the      ButtonReduce the volume level of the connected/paired devicePair the external BT Device to the unit as page 2.Place the external BT device close to the unitPOSSIBLE CAUSEBuilt in battery drainedVolume of the unit was set to minimum positionVolume level of paired/connected device is in low levelVolume level too highVolume level of the connected/paired device too highThe external BT Device had NOT paired to the unitThe external BT device too far from the unitSYMPTOMCan’t power onNo sound or sound weakSound distortionBT not functioningC. Do not charge longer than 24 hours. Excessive charging      or running the unit until battery fully drains will damage      battery. Battery life will be extended if you keep the      battery fully charged.D. Battery life naturally shortens slowly over time.E. The rechargeable battery incorporated in this product is      not user replaceable.OPERATION:BT (Bluetooth) pairing:First time use or re-pairing the unit to a new BT Device, pair as follows:1. Power on the unit by pressing and holding the M Button     on the top of the unit approximately 1 second until the      White Indicator on the top of unit is illuminate and blink.     The unit will enter to BT (Bluetooth) mode automatically.     (If Micro SD Card and/ or Audio Connection Cable was     inserted into the unit. Unplug them from unit before power     on or press the M Button repeatedly to switch to BT mode.)2. Power on the external BT Device and enter to BT     searching mode. Start pairing following the on screen     instructions from the external BT Device. After paired,     the unit will sound a prompt tone and the White Indicator     will stop blinking.3. If pairing is complete you may now play music and answer     calls with your external BT Device.4. During playback:    ● Press the ► Button on the unit to pause, press again        to resume normalplayback.     ● Press and holding the      or      Buttons to adjust volume        level as desired.    ● Press and release the      or      Buttons repeatedly to        skip tracks.    ● Press the M Button repeatedly to switch to other        playback mode.5. If the unit is paired to a Cell Phone and a call is incoming     during an active music session, press the ► Button to     pause the music playback. Then speak to the built- in     microphone to answer the call. When your call is complete,     press the ► Button to disconnect or end the call and     resume to music playback.6. When finished listening, press and hold the M Button to     shut off the unit.3MODEL: MMA3639PLEASE READ BEFORE OPERATING THIS EQUIPMENT.OWNER'S MANUAL®Craig Electronics warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 180 days from date of purchase. If service is required, please return the product to the store where it was purchased for exchange; or, pack the unit in the original packing material with all accessories if applicable, a copy of your sales receipt and a Cashier’s check or Money Order for $12 (to cover shipping and handling costs) payable to Craig Electronics Inc. For consumers in Canada, please make sure that the cashier check or money order is redeemable through a U.S. bank. Ship your product freight pre-paid. Your unit will be repaired, replaced or if the unit cannot be repaired or replaced, a refund will be forwarded to you within four weeks of receipt of your unit. Please ship your unit to:Craig Electronics Inc.1160 NW 163 DriveMiami, Fl 33169This warranty is void if the product has been: a) Used in a commercial application or rental. b) Damaged through misuse, negligence, or abuse. c) Modified or repaired by anyone other than an authorized Craig service center. d) Damaged because it is improperly connected to any other equipment.Note: This warranty does not cover: a) Ordinary adjustments as outlined in the Owner’s Manual which can be performed by the customer. b) Damage to equipment not properly connected to the product. c) Any cost incurred in shipping the product for repair. d) Damage to the product not used in the USA.This warranty is not transferable and only applies to the original purchase. Any implied warranties, including the warranty of merchantability, are limited in duration to the period of this expressed warranty and no warranty whether expressed or implied shall apply to the product thereafter.Under no circumstance shall Craig be liable for any loss or consequential damage arising out of the use of this product. This warranty gives specific legal rights. However, you may have other rights which may vary from state to state. Some states do not allow limitations on implied warranties or exclusion of consequential damage. Therefore, these restrictions may not apply to you.This product has been manufactured by and is sold under the responsibility of Craig Electronics Inc, and Craig Electronics Inc  is the warrantor in relation to this product. MAGNAVOX and SMART. VERY SMART are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V.To Obtain Service on your Productemail:service@craigelectronics.comPrinted in China  MMA3639_WC_E0FK1_B0WULIMITED WARRANTYNotes:● When the external BT Device searched the unit, our model    number “MMA3639” will appear on the display of external    BT Device.● If while pairing you are asked for a code please try "0000"    or "1234".Normal operation after pairing:1. Power on the unit by pressing and holding the M Button     on the top of the unit approximately 1 second until the     White Indicator on the front of unit is illuminate and blink.     The unit will enter to BT (Bluetooth) mode automatically.     (If Micro SD Card and/or Audio Connection Cable was     inserted into the unit, press the M Button repeatedly to     switch to BT mode.)2. Wait a few seconds until the unit is automatically paired     to the external BT Device3. After pairing is complete, the unit will sound a prompt     tone and the White Indicator will stop blinking. You may     now play music and answer calls with your external BT     Device.LINE IN:To listen from an external Audio Player such as a MP3 Player, Discman …etc.1. Open the Rubber Cover on the rear of unit.2. Connect one end of the supplied Audio Connection Cable     to the AUX Out/Line Out/Phone Jack on the external     Audio Player.3. In power on mode, connect the other end of the cable to     the LINE IN Jack as the illustrated below. The unit will     turn to LINE IN mode automatically.          To AUX Out/Line Out/          Phone Jack on the           external Audio Player        4. Play the music on the connected Player as usual. (Make     sure the volume level of the connected Audio Player is     turned to high level.)5. During playback:    ● Press the ► Button to mute the sound, press again to        turn the sound back.     ● Press and holding the     or     Buttons to adjust volume        level as desired.    ● Press the M Button repeatedly to switch to other        playback mode. 6. When finished listening, press and hold the M Button to     shut off the unit.4Micro SD Card:1. Open the Rubber Cover on the rear of unit.2. Insert the Micro SD Card into the Micro SD Card Slot     with contact finger face to up as the illustrated follows:3. Power on the unit by pressing and holding the M Button     on the top of the unit approximately 1 second. The unit     will plays the song/music on the Micro SD Card     automatically.4. During playback:    ● Press the ► Button to mute the sound, press again to        turn the sound back.     ● Press and holding the      or      Buttons to adjust        volume level as desired.    ● Press and release the      or      Buttons repeatedly to        skip tracks.    ● Press the M Button repeatedly to switch to other        playback mode. 5. When finished listening, press and hold the M Button to     shut off the unit.Notes:● Up to 16 GB Micro SD Card the unit support to play.● Before replacing Micro SD Card, make sure the unit has    been powered off.● When inserting the Micro SD Card, make sure the    direction you selected is correct. Never insert violently to    avoid damaging the Micro SD Card or the unit.● If it doesn’t work, please check if the direction is correct.● You also need to download the desired music in MP3    format into the Micro SD Card before insert into the unit.RESET:If the unit is halt or abnormal operation, press the Reset Button by a small screw driver (not included) to shut it off. Press and holding the M Button approxi-mate 1 second to power on it again.5TROUBLESHOOTING:Check the following before requesting service:SPECIFICATIONS:PACKAGE INCLUDES: 1 x User's Manual1 x USB Connection Cable (For charge only)1 x Audio Connection Cables with 3.5mm Plugs SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE.6LOCATION OF CONTROLS:                                                                                                                                                 1. M Button                                                                                                                                                                                                                           2.     Button                                                                                                                                                                                                                                                          3. ►Button                                        4.     Button                                        5. White Indictor                                       6. Rubber Cover (This cover is for                                           water and dusts Ingress                                           Protection; always make sure it                                            is completely closed)                                         7. LINE IN Jack                                       8. Micro USB Port (For charge only)                                       9. Micro SD Card Slot                                     10. Red Charging Indictor                                     11. Reset Button (Inside the hole)                                     12. Built-in Microphone                                                                                                                                                                                                                                                                                                                                                     13. Metallic BucklePOWER SOURCE:The unit has a built in Li-ion rechargeable battery, recharge it before use or when the battery is drained as follows:1. Open the Rubber Cover on the rear of unit.2. Connect the Micro USB Plug from the supplied USB     Connection Cable to the Micro USB Port.3. Connect the full sized USB Plug from the supplied USB     Connection Cable to the USB Port on Computer or USB     Charger (Not included).Charging will automatically start.     ● During charging, the Red Charging Indicator on the rear        of unit will illuminate. When finished, it will turn off.     ● During charging, you can also play and listen music at        the same time.                                                 To Computer or any USB Charger   NOTES:The Rubber cover is for water and dusts Ingress Protection; always make sure it is completely closed.                              IMPORTANT:Your battery will last longer if you're following these simple guidelines for charging and storing.A. Before first time use, charge it approximately 4 hours until     the unit is fully charged.B. Recharge and store the unit within the temperature range     of 5°C~35°(40°F~95°F).2Power SourceDusts/Water Ingress Protection Level Impedance of SpeakersAudio PowerBT VersionBT Operation Distance                                   Built-in DC        3.7V, 1000 mAH(3.7WH) rechargeable Li-ion battery; Recharge by DC         5V through Micro USB PortIP672 x 5 W; 3 ohm3W per Channel (Total 6 W, RMS)4.1≧ 32 Feet in open area Portable waterproof SpeakerMMA3639, A023

Navigation menu