Abocom Systems FE2500A User Manual

Download:
Mirror Download [FCC.gov]
Document ID	81767
Application ID	s170cQp2f/4FfO61Cdz21A==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	30.81kB (385165 bits)
Date Submitted	2000-01-18 00:00:00
Date Available	2000-01-28 00:00:00
Creation Date	2000-01-18 13:51:39
Producing Software	Acrobat 4.0 Scan Plug-in for Windows
Document Lastmod	2000-01-18 13:52:09
Document Title	User Manual
Document Creator	Acrobat 4.0 Scan Plug-in for Windows

FCQID: (“CM FE zsoog
USER'S MANUAL
CardBus 10/100 Ethernet
PC Card Adapter
nm Edninn um. 27. m9)
Dncunmeo MOI-YEZSW-mtl o
FCC Part 15 ,Class B Certification
Statement
FCC ID: MQ4FE2500A
The United States Fedenll Communication Commission
(FCC) and the Canadian Depnnment of Communiwions
have ntabltshcd certain mles governing the usc of electronic
equtpment.
This tieVlce complies with Part I5 DfFCC rules Operation is
subject to the following two conditions:
l)TIl|s device may not cause harmful interface, and
2)This device must accept any interface received,
including interface that may cause undesired operation.
wttrni gzrttis equipment has been tested and found to
comply with tlte limits for a Class B digital device, pursuant
to art 15 of the FCC Rules, These limits are designed to
prthde reasonable protection against harmful interference
in a residential thstallolion. This equipment generates, uses
and can radiate radio frequency energy, and if not installed
and ttscd in accordance with tlte instructions, may cause
harmful interference to radio communications However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment doos crtuse harmful
interference to radio or television reception, which can be
determined by turning on and on, the user is encouraged to
try to correct the interference by one or more oi'tlie following
measures:
A Reorlent or relocate the receiving antenna.
A increase the distance between the
equipment and receiver.
A Connect the equipment into an outlet on u circuit
dttterent from that to which the rcceiver ls
Connected to.
A Consulr the dcaler or an experienced radtorrv
technietan for help.
To assure continued compliance, use only shielded
interface cables when connecting computer to
pertphml devices. Any changes or modifications
not expressly approved by the party responsible for
compliance could Void the user‘s authority to
operate this equipment,
CONTENTS...
INTRODUCTION TO CARDBUS ......
HARDWARE INSTALLATION ......
SOFTWARE INSTALLATION“
Windows 95 Installation...
Windows NT 4.0 Inna/[align
Window: NT 3. 5x Insla/Ialio
DOS Mode Installation .
Novel! Nelvmre.
MS LAN Manager
Packet Driver
Windows for Workgmups 3,1]
Anisofi Lnnlaslic 6.0 Installation .
QUESTIONS & ANSWERS ......
SPECIFICATIONS ......
About This Manual
This manual will explain how to install and use your
10/100Mbps dual speeds Fast Ethernet PC Card. The
following guideline will help you through the
installation process
Chatper 1 presents you the basic information about
the CardBus technology It also provide some
methods to ensure your notebook are CardBus
equipped and correctly configured.
Atter you already make sure your mobile computer is
ready to run CardBus IO/IOOM Ethemel PC Card
You can go on the Chapter 2 to know how to install
the PC Card and Connect it to network
The CardBus I0/100M Ethernet PC Card provides
wide range of drivers sofiware to meet your need. You
can pick up the section within Chapter 3 to install and
configure the network driver.
The Questions and Answers listed in the Chapter 4
give you some solutions when you encouter problem
during installation the network drivrers.
Finally you can find the detail specification of this
innovative product in the Appendix A,
System Requirement
0 An IBM compatible notebook computer with 486
or faster processor with CardBus supported socket
- Drivers and utilities__provided with this product
0 PCMClA PC Card compliant Card Services and
Socket Services
0 IOOBase-TX Fast Ethernet or IOBaseT Ethernet
connectivity to your local area network
Operating Environments
Windows 95, Windows 95 OSR2, Windows 98
Novell Netware 3ix, 4.x
Microsofi Windows NT 3.51, NT 4.0
Microsofl LAN Manager
Packet Driver Applications
Microsofi Windows for Workgroups 3.11
Microsott Windows 3A]
Lantastic 60
-.co-...
Contents in the Package
0 CardBus 10/100 Ethemel PC Card Adapter
0 Media coupler with single RJ-45 connector for
lOBASE~T and lOOBASE-TX network,
. 3.5” driverdiskette
User’s Manual
Plastic protection case for base PC Card
INTRODU ION TO CAR US
Cardbus is the next generation 32-bit version issued
by PCMCIA PC Card slandardJn addition to support a
wider bus (32 bits instead of 16 bits), CardBus also
supports bus mastering and operation speeds up to 33
MHz. The l32MByles bus tranfer rate ( compares
with legacy l6-bit l/O PC Card ,20MByte) provides
the mobil user to enjoy the high-bandwith network
connection
A mohil computer which equipped with CardBus
and properly configured is the fundamental require-
ment to use the CardBus 10/ 100M PC Card To make
sure about this point, please follow the guideline listed
below:
0 Cardbus is designed to support both 16-bit and
Cardbus Cardi But the legacy 16-bit PC Card slot
couldn't accept the CardBus PC Card In oder to
prevent the wrong operation, CardBus is developed
with particular machanical consideration to prevent
it fit into the legacy 16-bit PC Card Slot. If you can't
insert the CardBus 10/100 PC Card into the slot
firmly reaching the bottom, your notebook probably
hasn‘t the capability to support CardBus techno-
logy. Please check your notebook manual for detail
information.
NoteBook with only
16 bil PC_ _Card
CardBus equipped
NoteBook
15bit PC Card
CardBus PC Card
0 Due to variant design of notebook computers , some
models implement a setting in the Computer ‘5
BIOS to switch between Cardbus and 16-bit PC
Card modes, You could consult the User’s Guide of
your notebook and properly set on the CardBus or
Auto_Deteet model
HARDWARE IN
This chapter describes how to install the CardBus
lO/lOOM dual-speed PC Card in your notebook
computer and connect it to network. lt’s referred to
“the PC Card” in this manual,
The PC Card could be connected to either lOOMbps
Fast Ethernet or lOMbps Ethernet over unshielded
twisted pair (UTP) calber The PC Card have the ability
of automatic sensing and operating on either speed
without manual recofiguration.
Afier finishing the installation of PC Card into your
Notebook, please refer to Chapterj Software
Installation on how to install network drivers using
menu driven installation utility.
Inserting the CardBus Dual—Speed PC Card
I.Hold the CardBus PC Card with wide connector
toward the slot and the brand lable facing upward.
2. Insert the CardBus PC Card and push it firmly into
the bottom,
( Please see the figuer on the next page for reference)
Removing the CardBus Dual-Speed PC Card
it’s quite different for various computer mechanical
design Please refer to the PC Card removal instruction
in the document for your notebook computer.
_______—
Connecting and Removing the Cable of
Media Coupler to the CardBus PC Card
Grasp the PC Card lS-pins connector at the end of the
media coupler with the pointing triangle facing
upwardi Gently insert it into the mating connector on
the PC Card until it clicks in place at both sides.
Attention should be paid when removing the lS-pins
connector. Please press _the both sides ofthe
connectors before dragging it out of the PC Card.
_._____————
Connecting to the Network
Connect unshielded twisted pair (UTP) cable to the
R145 connector of media coupler before loading any
network driver.
0 For operation in theIOOMhps (lOOBase-TX)
Ethernet network, a Category 5 unshielded twisted
pair(UTP) cable should be used to connect between
media coupler and lOOMbps hub or switch,
oFor operation in (he lOMbps (lOBase-T) Ethernet
network, Category 3, 4 or 5 unshielded twisted pair
(UTP) cable could be used to connect between the
media coupler and a lOMbps hub or switch.
LED Indicators
Acllvily: Blink
Orange
10mm: On n 2 o
iOMbps :o« Link Imegr y n
ns
E] SPECIFICATIONS
Network Interface Specifications
OIOMbps ELhemel: IEEE 802.3 standard IOBaseT
baseband CSMA/CD local area nclwork,
oIOOMbps Elhemel; IEEE 802.3u standard IOOBase-
TX baseband CSMA/CD local area network.
‘20/200Mbps full duplex support
oAutonegotiation between all four operation
modes.
Host Interface and Physical S ecil‘ications
oCardbus PC Card Standard compliant.
oType II PC Card form factor
o3.37" x 2.128” x 0.197" (86mm x 54mm x 5.0mm}
o40gw in weight
Operating Environments
Novel] Nclware 3.x, 4.x
Microsofi LAN Manager
Packet Driver Applicalicns
Microsofi Windows for Workgmups 3.1 I, Windows 3.1
Microsofi Windows NT 3.5x, NT 4.0
Windows 95, 95 OSRZ, 98
Lanmstic 6,0
33
Specificalinns
General S ecification
LEDs: Link , Activity, lO/lOOMbps
Enviroments Ranges:
Operating: 32°F to 149°F (0°C to 65°C)
Storage: -4°Flo 158“F (-10°Cto 70°C)
Humidity: l0% - 90% , noncondensing
Certifications: FCC, Pm IS, Class B
CE Mark (EN55022,ClassB, ENSOOSZ-l)
VCCI Class B
34

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Modify Date                     : 2000:01:18 13:52:09-05:00
Create Date                     : 2000:01:18 13:51:39-05:00
Creator                         : Acrobat 4.0 Scan Plug-in for Windows
Producer                        : Acrobat 4.0 Scan Plug-in for Windows
Page Count                      : 12

EXIF Metadata provided by EXIF.tools