Abocom Systems FW200 IEEE 1394 Cardbus PC Card User Manual page

Download:
Mirror Download [FCC.gov]
Document ID	128503
Application ID	X7IUKSf9PWKg6GsYKtnr2g==
Document Description	manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	395.77kB (4947100 bits)
Date Submitted	2000-12-13 00:00:00
Date Available	2000-12-13 00:00:00
Creation Date	2000-11-15 12:53:03
Producing Software	Acrobat PDFWriter 4.0 for Windows
Document Lastmod	2000-11-22 19:21:06
Document Title	page)
Document Creator	Print Untitled (1 page)
Document Author:	Feng

Dual-Port IEEE 1394
CardBus PC Card
Installation Guide
FCC REGULATORY STATEMENTS
Part15, Class B
This device complies with Part 15 of FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interface, and
2. This device must accept any interface received,
including interface that may cause undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
0 Reorient or relocate the receiving antenna.
0 hicrease the distance between the equipment and
receiver.
0 Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
(9 Changes or modifications not expressly approved
by party responsible for compliance could void the
user the user authority to operate the equipment.
INTRODUCITON
About IEEE 1394 and This Product
The IEEE 1394 High Performance Serial Bus,
also called FireWire, provides an affordable,
versatile, high-speed, non-proprietary
interconnect for all digital devices
Providing bus master function data transfer
between CardBus and IEEE1394 buses, this Dual-
Port IEEE 1394 CardBus PC Card is especially
designed for notebook worriers who can then
connect to FireWire peripherals. You can
connects up to 63 nodes, including printers,
digital videos camcorders, hard disks, scanners,
etc. Plus, there's no dongle needed! The IEEE
CardBus PC Card makes a true universal
connection available.
Features
' Complies with IEEE 1394a
' Dual-port supported: one 4-pin and one 6—pin
1394 unpower ports for versatile connections
- Connects up to 63 devices
' Up to 16 consecutive cable hops of 4.5 meters
- F ireWire speed up to 400Mbps
- Compatible with most DV/mimDV Camcorders
& other powered 1394 peripherals.
- Type II CardBus PC Card
' Supports “Hot-Swapping” ',
.1.
' Supports Plug and play
- Synchronous and asynchronous data transfer
- Attached ports, no dongle is required
System Requirements:
0 Notebook with CardBusTM interface
0 Processor: Pentium 166 MHz or higher
0 Memory 16 MB or higher
0 Windows 98 or 2000 Operating SystemTM
HARDWARE INSTALLATION
Parts names:
1. 6-pin connector.
2. 4-pin connector
Connection
SOFTWARE INSTALLATION
Before you start, make sure the drivers of
CardBus slot are well installed.1
Windows 98 Installation
1. Insert this PC card into the CardBus slot.
Windows 98 will automatically detect the
new device. Click Next to proceed.
2. Then Windows will prompt a ADD NEW
HARDWARE WIZARD dialog box. In this
time, select Search for the and press
Next.
' The System Icon in the Control Panel can report on its
functionality. ‘
.4.
Windows will prompt a Add New Hardware
Wizard dialog box, in this time, select
Specify a location and enter the drive and
directory where your original Windows 98
installation or setup files reside. Windows
will begin copying the needed files. You may
need to load the original Windows 98
CD/disks if those files were not copied onto
your computer previously.
5. When finished, click Finish to activate the
new device.
Windows 2000/ME Installation
For both Windows 2000 and Windows Millenium
Edition, Windows system will automatically
install the driver for this Dual-Port IEEE 1394
CardBus PC Card as long as the CardBus slot
driver was well installed onto your computer.
Be sure to direct the appropriate location for
system to copy the necessary files from the
Windows source files, or you may need to load
the original Windows 2000/ME CD.
When the installation is finished, you may go to
Start—>Setting—>Control
Panel—>System—->Device Manager to check if
1394 Bus Controller has been successfillly
installed.
Windows 2000
.1.
APPENDIX A SPCIFICATIONS
o IEEE 1394A and IEEE 1394-1995
Compliant
o OHCI 1.0 Compliant
0 Type II CardBus PC Card
0 1394 Ports: One 4-pin, one
o 32 bit Bus Mastering .,.
. Windows 98 & 2000 ' ~ '
o 400 Mbps max transfer-fl
0 Support for 100. 200. 400 Mbps
. FCC, CE, and VCCI Certified

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Creator                         : Print Untitled (1 page)
Create Date                     : 2000:11:15 12:53:03
Title                           : page)
Author                          : Feng
Producer                        : Acrobat PDFWriter 4.0 for Windows
Modify Date                     : 2000:11:22 19:21:06+08:00
Page Count                      : 10

EXIF Metadata provided by EXIF.tools