Acer orporated DME600 Smart HandHeld User Manual Safety

Download:
Mirror Download [FCC.gov]
Document ID	2390411
Application ID	YJa44m6WZJVVTNgbdFWDmA==
Document Description	Safety
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	5.44kB (67946 bits)
Date Submitted	2014-09-16 00:00:00
Date Available	2015-03-15 00:00:00
Creation Date	2017-10-21 05:38:04
Producing Software	GPL Ghostscript 9.18
Document Lastmod	2017-10-21 05:38:04
Document Title	Safety
Document Creator	Acrobat PDFMaker 10.1 Word 版
Document Author:	Benson Chen (陳建旭)

Safety
Replacing the battery
Replace the battery with the same type as that which came bundled with your
product. Use of another battery may present a risk of fire or explosion.
-------------------------------------------------Warning! Batteries may explode if not handled properly. Do not disassemble
or dispose of them in fire. Keep them away from children. Follow local
regulations when disposing of used batteries.
----------------------------------------------------
Disposal and recycling information
Do not throw this electronic device into the trash when discarding. To minimize
pollution and ensure utmost protection of the global environment, please
recycle. For more information on the Waste from Electrical and Electronics
Equipment (WEEE) regulations, visit
www.acer- group.com/public/Sustainability
It is compliant with WEEE regulation
RoHS compliance
This product is in compliance with Directive 2011/65/EU of the European Parliament
and of the Council of 8 June 2011, on the restriction of the use of certain hazardous
substances (RoHS) in electrical and electronic equipment and its amendments.
FCC regulations
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiated radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
IC regulations
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement."
CAN ICES-3(B)/NMB-3(B)
RF exposure information (SAR)
This device meets the FCC/IC requirements on the limitation of exposure of the
general public to electromagnetic fields by way of health protection.
The unit of measurement for the FCC/IC limit is the "Specific Absorption Rate" (SAR).
The SAR limit set by the FCC/IC is 1.6 W/kg, averaged over 1 g of tissue. The FCC
and IC have granted an Equipment Authorization for this device with all reported
SAR levels evaluated as in compliance with the FCC and IC RF exposure guidelines.
SAR information on this device is on file with the FCC and can be found under the
Display Grant section of www.fcc.gov/oet/ea/fccid after searching on the FCC ID for
your device, which can be found on the product labeling of your device.
For body-worn operation, this device has been tested use with accessories that
contain no metal and that position the handset a minimum of 1.0 cm from the body.
Use of other accessories may not ensure compliance with RF exposure. If you do
not use a body-worn accessory and are not holding the device at the ear, position
the handset a minimum of 1.0 cm from your body when the device is switched on.
During use, the actual SAR level is usually much lower than the maximum value. In
general, the closer you are to a base station, the lower the transmission output of
your device. To reduce exposure to RF energy, use a hands-free accessory or other
similar option to keep this device away from your head and body.
Hearing Aid Compatibility Information (HAC)
Your device is compliant with the FCC Hearing Aid Compatibility (HAC) requirements.
The FCC has adopted HAC rules for digital wireless phones. These rule require
certain phone to be tested and rated under the American National Standard Institute
(ANSI) C63.19 hearing aid compatibility standards. The ANSI standard for hearing
aid compatibility contains two types of ratings:
M-Ratings: Rating for less radio frequency interference to enable acoustic coupling
with hearing aids.
T-Ratings: Rating for inductive coupling with hearing aids in telecoil mode.
Not all phones have been rated, a phone is considered hearing aid compatible under
FCC rules if it is rated M3 or M4 for acoustic coupling and T3 or T4 for inductive
coupling. These ratings are not guarantees. Results will vary, depending on the level
of immunity of your hearing device and the degree of your hearing loss. If your
hearing device happens to be vulnerable to interference, you may not be able to use
a rated phone successfully. Trying out the phone with your hearing device is the best
way to evaluate it for your personal needs.
This phone has been tested and rated for use with hearing aids for some of the
wireless technologies that it uses. However, there may be some newer wireless
technologies used in this phone that have not been tested yet for use with hearing
aids. It is important to try the different features of this phone thoroughly and in
different locations, using your hearing aid or cochlear implant, to determine if you
hear any interfering noise. Consult your service provider or the manufacturer of this
phone for information on hearing aid compatibility. If you have questions about return
or exchange policies, consult your service provider or phone retailer.
Hearing devices may also be rated. Your hearing device manufacturer or hearing
health professional may help you find this rating. For more information about FCC
Hearing Aid Compatibility, please go to http://www.fcc.gov/cgb/dro.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract, Print high-res
Author                          : Benson Chen (陳建旭)
Create Date                     : 2014:09:02 15:50:22+08:00
Modify Date                     : 2014:09:10 16:34:54+08:00
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Metadata Date                   : 2014:09:10 16:34:54+08:00
Creator Tool                    : Acrobat PDFMaker 10.1 Word 版
Document ID                     : uuid:bcc94458-dced-4377-a245-ab85da5f8938
Instance ID                     : uuid:81e6ad1a-54ac-43bb-a7ce-96ccae5af870
Subject                         : 2
Format                          : application/pdf
Creator                         : Benson Chen (陳建旭)
Producer                        : Adobe PDF Library 10.0
Source Modified                 : D:20140320081648
Company                         : Sporton International Inc.
Page Layout                     : OneColumn
Page Count                      : 2

EXIF Metadata provided by EXIF.tools