Acer orporated DMS55 Smart HandHeld User Manual Manual
Acer Incorporated Smart HandHeld Manual
Manual
Safety
Replacing the battery
Replace the battery with the same type as that which came bundled with your
product. Use of another battery may present a risk of fire or explosion.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Warning! Batteries may explode if not handled properly. Do not disassemble
or dispose of them in fire. Keep them away from children. Follow local
regulations when disposing of used batteries.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Disposal and recycling information
Do not throw this electronic device into the trash when discarding. To minimize
pollution and ensure utmost protection of the global environment, please
recycle. For more information on the Waste from Electrical and Electronics
Equipment (WEEE) regulations, visit
www.acer- group.com/public/Sustainability
It is compliant with WEEE regulation
RoHS compliance
This product is in compliance with Directive 2011/65/EU of the European Parliament
and of the Council of 8 June 2011, on the restriction of the use of certain hazardous
substances (RoHS) in electrical and electronic equipment and its amendments.
FCC regulations
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiated radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
IC regulations
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement."
CAN ICES-3(B)/NMB-3(B)
RF exposure information (SAR)
This device meets the FCC/IC requirements on the limitation of exposure of the
general public to electromagnetic fields by way of health protection.
The unit of measurement for the FCC/IC limit is the "Specific Absorption Rate" (SAR).
The SAR limit set by the FCC/IC is 1.6 W/kg, averaged over 1 g of tissue. The FCC
and IC have granted an Equipment Authorization for this device with all reported
SAR levels evaluated as in compliance with the FCC and IC RF exposure guidelines.
SAR information on this device is on file with the FCC and can be found under the
Display Grant section of www.fcc.gov/oet/ea/fccid after searching on the FCC ID for
your device, which can be found on the product labeling of your device.
For body-worn operation, this device has been tested use with accessories that
contain no metal and that position the handset a minimum of 1.0 cm from the body.
Use of other accessories may not ensure compliance with RF exposure. If you do
not use a body-worn accessory and are not holding the device at the ear, position
the handset a minimum of 1.0 cm from your body when the device is switched on.
During use, the actual SAR level is usually much lower than the maximum value. In
general, the closer you are to a base station, the lower the transmission output of
your device. To reduce exposure to RF energy, use a hands-free accessory or other
similar option to keep this device away from your head and body.