Acrox Technologies MU60 Full-Size Ergonomic Wireless Mouse with Fast Scrolling User Manual
Acrox Technologies Co., Ltd. Full-Size Ergonomic Wireless Mouse with Fast Scrolling
User Manual
Model Name: G6B
Ergonomic Wireless Mouse - DPI
adjustable
USER'S GUIDE
Ver.:1.00
CAUTION: To use this product properly, please read the user's guide before installing.
1
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiation Exposure Statement:
The product comply with the FCC portable RF exposure limit set forth for an
uncontrolled environment and are safe for intended operation as described in
this manual. The further RF exposure reduction can be achieved if the
product can be kept as far as possible from the user body or set the device to
lower output power if such function is available.
2
IC Notice:
This device complies with Canada Industry licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference. and (2) this device must accept any interference.
Including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage; (2) l’utilisateur de l’appareil
doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
CAN ICES-3 (B) / NMB-3 (B)
3
Functional Introduction
Forward
Press this button to view the next page in your Internet browser.
Backward
Press this button to view the previous page in your Internet browser.
DPI Switch
a) 5 adjustable DPI
The blink on key indicates
he DPI setting in use
DPI Blink
600 dpi 1
1000 dpi 2
1600 dpi 3
2400 dpi 4
3600 dpi 5
b) Default is 1600 DPI
Left button
Right button
Battery Cover
Scrolling Wheel
ON/OFF
Switch
Nano Receiver
Backward
Forward
DPI Switch Key
4
Encrypted air-protocol with AES 128
AES (Advance Encryption Standard) is a specification for the encryption
of electronic data.
Installing the batteries
Step 1: Take the battery cover off.
Step 2: Insert the battery as shown inside the battery compartment.
Step 3: Replace the cover.
Step 4: Turn on power switch
AA Battery
Pull
5
**Warning:
*Please insert the battery with the correct position according to the instruction
labeled on the mouse.
Step 5: If you need to travel with your wireless mouse, made sure you
turn off the POWER SWITCH.
Setup the Connection between the Receiver and
the Mouse
1. Insert the battery into the mouse, then follow the steps below.
2. In the meantime, a storage slot on the back to storage the receiver ,
take the nano receiver out.
3. Plug the Nano receiver into the USB port on your computer.