Acrox Technologies OPWIMTMU01 Wireless Mouse User Manual Users Manaul

Acrox Technologies Co., Ltd. Wireless Mouse Users Manaul

Users Manaul

Download: Acrox Technologies OPWIMTMU01 Wireless Mouse User Manual Users Manaul
Mirror Download [FCC.gov]Acrox Technologies OPWIMTMU01 Wireless Mouse User Manual Users Manaul
Document ID1080827
Application IDn+3CMiIY8mD/b0iI/wBs/A==
Document DescriptionUsers Manaul
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize168.8kB (2109997 bits)
Date Submitted2009-03-15 00:00:00
Date Available2009-03-15 00:00:00
Creation Date2009-02-26 10:55:23
Producing SoftwareAdobe PDF Library 7.0
Document Lastmod2009-03-13 11:48:34
Document TitleUsers Manaul
Document CreatorAdobe InDesign CS2 (4.0)

Wireless Mouse
AMW25US-30
Introduction
Congratulations on your purchase of the Targus Wireless
Stow-N-GoTM Laptop Mouse with Micro USB Receiver.
The Stow-N-GoTM receiver clips onto the mouse for ease
of use while traveling or on the go. This is a plug and play
device so no additional software is required.
System Requirements
Hardware
• USB port
Operating System
• Windows® 2000
• Windows® XP
• Windows Vista®
• Mac OS® X v10.4 (or later)
Installing the Batteries
1. Remove the battery cover from the back of the mouse by sliding
off the cover of the mouse. Hold the mouse in your hands and
with the back of the mouse away from you. Press down on the
corners of the battery cover and slide towards the back of the
mouse. Lift the cover off from the back of the mouse.
2. Insert two AA-size batteries, making sure that the positive (+) and
negative (-) ends of each battery match the polarity indicators
inside the battery compartment. To replace the battery cover,
place the cover on top of the mouse and slide forward until it
clicks into place.
Establishing the Connection
(A) Remove the USB receiver from the bottom of the mouse.
(B) Plug the USB receiver into an available USB port on your
computer.
This mouse is a plug-n-play device. It should automatically operate
when the USB receiver is connected to the computer.
If you experience interference during use or if the mouse doesn’t
respond, follow the below steps to change the connection
channel.
(1) Unplug the micro USB receiver and plug it into another available
USB port.
(2) Press the connection button on the mouse.
(3) If there’s still no response from the mouse, switch the mouse
off, then switch the mouse back on again.
Product Specification
Transmitter
RF
2403MHz~2471MHz
Battery Type
Alkaline battery AA
Effective RF
Communication Range
10 meters max
RF output power
76.66dBuV/m
Receiver
RF
2403MHz-2471MHz
Interface
USB 1.1
Power
3Vdc, 100mA from Battery
Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction
with any other antenna or transmitter.
Changes or modifications not authorized by the party responsible for compliance
could void the user's authority to operate this product.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Declaration of Conformity
Hereby, Targus Group International, declares that this device is in
compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
Microsoft, Windows, and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. All trademarks and registered
trademarks are the properties of their respective owners. All rights reserved.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
Linearized                      : No
Modify Date                     : 2009:03:13 11:48:34+08:00
Create Date                     : 2009:02:26 10:55:23+08:00
Creator                         : Adobe InDesign CS2 (4.0)
Producer                        : Adobe PDF Library 7.0
Page Count                      : 7
For                             : Targus, Targus
Title                           : front.pdf
Bounding Box                    : -300 -74 302 486
Container Version               : 9
Creator Version                 : 12
PDF Version                     : 1.6
Has XFA                         : No
About                           : uuid:407c5ba4-24e2-493c-8108-f74baaf2d14f
Mod Date                        : 2009:03:13 11:48:34+08:00
Creation Date                   : 2009:02:26 10:55:23+08:00
Metadata Date                   : 2009:03:13 11:48:34+08:00
Document ID                     : uuid:bd0aced8-fb1f-4f1a-a86d-a9de44a52d47
Format                          : application/pdf
EXIF Metadata provided by EXIF.tools
FCC ID Filing: PRDOPWIMTMU01

Navigation menu