Acrox Technologies OPWIRWMU08 Wireless Mouse User Manual GK6 MRN T Manual 2010
Acrox Technologies Co., Ltd. Wireless Mouse GK6 MRN T Manual 2010
User Manual
2.4GHz Wireless
Hi-Low Blue Trace Mouse
w/Nano Receiver
USER'S GUIDE
Ver.:1.00
CAUTION: To use this product properly, please read the user's guide before installation
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Functional Introduction
Installing the batteries
Step 1: Take the battery cover off.
Step 2: Insert the batteries as shown inside the battery compartment.
Step 3: Replace the cover.
**Warning:
*Please insert the batteries with the correct position according to the instruction
labeled in the mouse.
Connect
Button
Left button
Right button
ON/OFF
Switch
LED Indicator
Pull
AAA Battery
1’st 2’nd
Hi-Low
Button
Metallic Wheel
Nano Receiver
Hi-Low Introduction
The perfect design for notebook users. This ultra slim, super small
mouse is ideal for on-the-go users, and can be used comfortably
anywhere, any time
Hi position
Low position
Setup the Connection between the Receiver and the Mouse
1. Insert the batteries into the mouse, then follow the steps below.
2. Push the trigger on the bottom of the mouse to reveal the hidden layer
Nano
Receiver
Push
3. Push out the Nano Receiver in the back of mouse then plug into your
PC/Laptop.
4. If the mouse is not working, please put it into pairing mode.
5. Pairing: Re-plug the receiver into the USB port of your computer, then
press the connect button on the mouse. If the mouse does not work
after 10 seconds, pair them again. (The receiver has auto pairing
function).
6.The LED indicator on mouse flashes steadily when it is in pairing
mode and stops blinking when it is successfully paired with the
receiver. The mouse’s LED indicator remains off afterwards.
7. When the batteries of the mouse is low, the Low Power indicator will
start to blink.
LED Indicator
*Mouse Indicator
Red LED Blinks 3 times
During Pairing
Red LED is on 3 sec.
Power ON
Low Battery Warning will blink
10 times when turn on.