Acrox Technologies OPWIRWMU27 Wireless Mouse User Manual 2 4G BlueTrace Mouse GM7 Nano RX Users Guide 2011

Acrox Technologies Co., Ltd. Wireless Mouse 2 4G BlueTrace Mouse GM7 Nano RX Users Guide 2011

User Manual

2.4GHz Wireless BlueTrace™ Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 Class 1 LED Product CAUTION: To use this product properly, please read the user's guide before installing.
1 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
2 Functional Introduction Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the batteries as shown inside the battery compartment. Step 3: Replace the cover. **Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse. Nano Receiver Scrolling Wheel & LED Indicator Left button Connect Button Right button Battery Cover Pull AAA Battery 1’st 2’nd ON/OFF Switch
3 Nano Receiver Setup the Connection between the Receiver and the Mouse 1. Insert the batteries into the mouse, then follow the steps below. 2. Plug the Nano receiver into the USB port of your computer. 3. If the mouse is not working, please put it into pairing mode. 4. Pairing: Re-plug the receiver into the USB port of your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function). Take out Push
4 5. The LED indicator on mouse flashes steadily when it is in pairing mode and stops blinking when it is successfully paired with the receiver. 6. When the batteries’ power of the mouse is low, the Low Power indicator will start to blink. LED Indicator *Mouse Indicator LED Blinks 3 times During Pairing LED is on 3 sec. Power ON Low Battery Warning will blink 10 times when turn on.

Navigation menu