Ademco 8DL5800STAT Security accessory User Manual

Honeywell International Inc. Security accessory II with FCC part 15 statements

a href="https://usermanual.wiki/Ademco" itemprop="url"> Ademco >

II with FCC part 15 statements

® U.S. Registered TrademarkCopyright © 2001 Honeywell • •All Rights Reserved INSTALLATION INSTRUCTIONS69- 1535T8665A Chronotherm® IVDeluxe Programmable Wireless ThermostatAPPLICATIONThe T8665 Chronotherm® IV Wireless Thermostat provides electronic control of 24 Vac heating and cooling systems. It must be used with a W8665 Receiver Module. Refer to Table 1 for a general description of the thermostat. The T8665A Thermostats are battery-powered.MERCURY NOTICEIf this control is replacing a control that contains mercury in a sealed tube, do not place your old control in the trash.Contact your local waste management authority for instructions regarding recycling and the proper disposal of the old thermostat.INSTALLATIONAccessory Required (Not Included)Select one of the receiver modules for your application:— W8665A Receiver Module (RM) for single zone applications.— W8665E RF Zone™ Panel for up to three zones.When Installing this Product...1. Read these instructions carefully. Failure to follow the instructions can damage the product or cause a hazardous condition.2. Check the ratings given in the instructions and on the product to make sure the product is suitable for your application.3. Installer must be a trained, experienced service technician.4. After completing installation, use these instructions to check out the product operation.LocationInstall the thermostat about 5 ft (1.5m) above the floor in an area with good air circulation at average temperature. See Fig. 1.Do not install the thermostat where it can be affected by:— drafts, or dead spots behind doors and in corners.— hot or cold air from ducts.— radiant heat from sun or appliances.— concealed pipes and chimneys.— unheated (uncooled) areas such as an outside wall behind the thermostat.Wallplate InstallationThe thermostat can be mounted horizontally on the wall or on a 2 in. x 4 in. wiring box. Position wallplate horizontally on the wall or on a 2 in. x 4 in. wiring box.1. Position and level the wallplate (for appearance only). The thermostat functions correctly even when not level.2. Use a pencil to mark the mounting holes. See Fig. 2.3. Remove the wallplate from the wall and drill two 3/16 in. holes in the wall (if drywall) as marked. For firmer material such as plaster, drill two 7/32 in. holes. 4. Gently tap anchors (provided) into the drilled holes until flush with the wall.5. Position the wallplate over the holes.6. Loosely insert the mounting screws into the holes.7. Tighten the mounting screws.Table 1. T8665A Thermostat Description.T8665 System Changeover System Selection Fan Selection CommentsA Heat-Cool Automatic Heat-Off-Cool-Auto On-Auto System and fan selections are entered at keyboard.
Download:
Mirror Download [FCC.gov]
Document ID166225
Application IDmCqhGwcExxOROeIaISWaLQ==
Document DescriptionII with FCC part 15 statements
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize26.21kB (327658 bits)
Date Submitted2001-08-24 00:00:00
Date Available2001-09-27 00:00:00
Creation Date2001-07-12 15:27:40
Producing SoftwareAcrobat Distiller 4.05 for Windows
Document Lastmod2001-08-23 13:24:37
Document Title69-1535 - Chronotherm IV Deluxe Programmable Wireless Thermostat
Document CreatorFrameMaker 6.0
Document Author: Home and Building Control
FCC ID Filing: CFS8DL5800STAT

Navigation menu