Ademco 8DL5815MN Security Door/Window Transmitter User Manual II with FCC statement

Download:
Mirror Download [FCC.gov]
Document ID	238413
Application ID	h2rHM6mGIuAPKYmnxna4UA==
Document Description	II with FCC statement
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	0.83kB (10327 bits)
Date Submitted	2002-04-23 00:00:00
Date Available	2002-06-06 00:00:00
Creation Date	2002-04-17 14:33:04
Producing Software	Acrobat Distiller 4.05 for Windows
Document Lastmod	2002-04-17 14:33:05
Document Title	II with FCC statement

K0017 4/16/02
ADEMCO
No. 5815MN
Contact Transmitter
Preliminary Installation Instructions
Use the 5815MN shock sensor only with alarm systems that support 5800 series wireless devices. The
transmitter has its own unique serial number permanently assigned during manufacture, which must be
entered into the control panel prior to the transmitter’s usage. Refer to the control unit’s installation
instruction for programming details.
Note: During programming of the control unit, 5815MN transmitters should be treated as “RF” (i.e.
supervised RF) Type. The 5815MN is assigned as one zone.
Mounting
Before mounting the transmitter permanently, conduct Go/No Go tests (see control’s instructions) to verify
adequate signal strength from the mounting location.
1) Learn serial number as described in the control panel installation instructions. To cause the sensor
to transmit, fault and restore the magnetic contact.
2) Determine mounting location.
3) Verify range by holding the sensor in the approximate mounting location and faulting the
magnetic contact. The panel (in test mode) should respond to the transmissions. If not, find a more
suitable mounting location.
4) Mount the transmitter and magnet with the appropriate mounting hardware.
5) Verify operation by faulting and restoring the magnetic contact – check for trip at alarm panel.
FCC Statement
FCC ID: CFS8DL5815MN
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Specifications
Contact Gap:
1/2 inch minimum
Unit Dimensions:
1.6” (40.64mm) x 1.6” (40.64mm) x 0.8” (20.32mm)
Battery:
Panasonic CR2, Sanyo CR2, and Duracell DLCR2.
Refer to the installation instructions for the receiver/control with which this device is used for warranty
information, and details regarding the limitations of the entire alarm system.
ADEMCO
GROUP
165 Eileen Way, Syosset NY 11791
Copyright© 2002 Pittway Corporation

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Create Date                     : 2002:04:17 14:33:04
Producer                        : Acrobat Distiller 4.05 for Windows
Modify Date                     : 2002:04:17 14:33:05-04:00
Page Count                      : 1

EXIF Metadata provided by EXIF.tools