Ademco 8DL5820L Door / Window Contact Transmitter User Manual

Honeywell International Inc. Door / Window Contact Transmitter Users Manual

a href="https://usermanual.wiki/Ademco" itemprop="url"> Ademco >

Users Manual

AdemcoK9230V35820L Exterior of boxFile: K9230V3_Blueline_Ademco_5820L_instruct_exterior.epsASSEMBLED IN MEXICO© 2009 Honeywell International Inc.All Rights ReservedLong Life Battery IncludedADEMCO 5820LSee inside of carton forInstallation Instructions Slim Line TransmitterSlim Line TransmitterADEMCO 5820LSlim Line Transmitter7/11 K9230V3ADEMCO 5820LSlim Line TransmitterADEMCO 5820L<<< Open Carton Along Perforations >>>Perforation (1/4" x 1/8")Ideal for casement anddouble hung windowsRRLITHIUMLITHIUMADEMCO 5820LSlim Line TransmitterFEDERAL COMMUNICATIONS COMMISSION STATEMENTS: The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.+MOUNTINGHOLEMOUNTINGHOLETAMPERPROTECTIONBATTERY(1.5VDC, AAALITHIUM.SEE NOTEINSIDE.)TAMPERSWITCHSleek design is nearly half the size of competitors Easy to open case requires no special toolsCase tamper protection (front and back)Ideal for double-hung windowsEasy replaceable AAA lithium batterySleek design is nearly half the size of competitors Easy to open case requires no special toolsCase tamper protection (front and back)Ideal for double-hung windowsEasy replaceable AAA lithium batteryFront and back-case tamper isprovided using the same switch.The front-case tamper is alwaysenabled. Adding the third screwas shown in the figure enablesthe back-case tamper.Tamper ProtectionN219ÊK9230V3HŠ
AdemcoK9230V35820L Interior of boxFile: K9230V3_Blueline_Ademco_5820L_instruct_interior.epsBattery InformationNOTEFOR DOCUMENTATION AND ONLINE SUPPORThttp://www.security.honeywell.com/hsc/resources/MyWebTechFOR WARRANTY INFORMATION GO TO:http://www.security.honeywell.com/hsc/resources/waSee inside ofcarton forinstallationinstructions.See inside ofcarton forinstallationinstructions.REFER TO THE INSTALLATIONINSTRUCTIONS FOR THE CONTROLWITH WHICH THIS DEVICE IS USED,FOR DETAILS REGARDINGLIMITATIONS OF THE ENTIREALARM SYSTEM.1.2.3.5820L is a single-zone Slim-LineDoor/Window contact transmitterthat provides wireless notificationof intrusion.Install mounting screwsin the two outsidemounting holes asshown in the diagramusing a #1 Phillips.If the case-back tamperswitch will be used,install a third screw inthe middle hole.Mount the magnet(supplied) adjacent tothe two verticalpositioning lines on thecase side (see diagram).The gap can be one-halfof an inch maximum.To reinstall the cover,position the cover sothat it covers themounted case-back, andsnap-shut. The two casehalves can only be fittedtogether in one direction.Temporarily mount the 5820Land magnet using the double-back tape provided.If the Go/No Go test wassuccessful, remove thetransmitters cover by insertingthe flat blade of a small screw-driver into the opening slot atone end of the unit as shownin the diagram and separate thetwo halves.The 5820L must only bemounted against a flat surface.A curved surface would causeundo stress to the unit andpossible failure to operateproperly.4.5.6.7.Before mounting permanentlyusing the double-back tape ormounting screws, conduct aGo/No Go test to verify adequatesignal strength and reorient orrelocate the transmitter if necessaryNOTEInstallationAlkaline Battery Will Yield LessBattery Life than LithiumReplace battery only with:Energizer L92 AAA Lithium orAAA Alkaline, Duracell MX2400,Panasonic AM-4PI,Eveready Engeriger EN92.BATTERY CAUTION: Risk of fire,explosion and burns. Do notrecharge, disassemble, heat above212 F (100 C) or incinerate.Dispose of used batteries properly.Keep away from children.Perforation (1/4 x 1/8)MAGNETOPENINGSLOTGAP 0.5" MAXMAGNET ALIGNMENTLOCATORSDo NOT attempt to removethe PCB from the plasticcover for any reason.NOTEDuring the programming of thecontrol panel transmitter must beenrolled as Input Type 3,Supervised RF), Loop 1.NOTEObserve correct polarity.FCC / IC Statement:This device complies with Part 15 of the FCC Rules, and RSS 210 of IC. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation.Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement est soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit accepter toute interference reçue y compris les interferences causant une reception indésirable.
Download:
Mirror Download [FCC.gov]
Document ID1513700
Application IDyqqiOkHrl1fvw1Fig0J8Xg==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize22.58kB (282263 bits)
Date Submitted2011-07-31 00:00:00
Date Available2012-01-27 00:00:00
Creation Date2011-07-05 15:14:50
Producing SoftwareAcrobat Distiller 9.0.0 (Windows)
Document Lastmod2011-07-05 15:44:24
Document TitleK9230V3_blueline_Ademco_5820L_instruct_exterior.eps
Document CreatorAdobe Illustrator CS5
Document Author: Barto, Bill (S&FS)
FCC ID Filing: CFS8DL5820L

Navigation menu