Ademco 8DLRF6FOB Lyric Smart Peripheral - Keyfob User Manual 2 Rev A

Honeywell International Inc. Lyric Smart Peripheral - Keyfob Users Manual 2 Rev A

Users Manual 2 - Rev A

This bi-directional wireless keyfob is intended for use with
Honeywell controls that support SiX™ series devices.
FC: This bi-directional wireless keyfob is intended for use with
Honeywell controls that support SiX™ series devices.
SP: This bi-directional wireless keyfob is intended for use with
Honeywell controls that support SiX™ series devices.
PA: This bi-directional wireless keyfob is intended for use with
Honeywell controls that support SiX™ series devices.
Note
: Once enrolled in a
system, the RF6FOB cannot be
used with another control panel
until it is removed from the
current control panel. See the
Control’s instructions device
removal instructions.
FC: Note
: Once enrolled in a
system, the RF6FOB cannot be
used with another control panel
until it is removed from the
current control panel. See the
Control’s instructions for device
removal instructions.
SP: Note
: Once enrolled in a
system, the RF6FOB cannot be
used with another control panel
until it is removed from the
current control panel. See the
Control’s instructions for device
removal instructions.
PA: Note
: Once enrolled in a
system, the RF6FOB cannot be
used with another control panel
until it is removed from the
current control panel. See the
Control’s instructions for device
removal instructions.
Enroll / Enroll / Enroll / Enroll
LEDs
Sounder
System Status
RED ON 2-3 seconds
2 beeps
System Armed (any mode)
RED Flashing slowly 2-3 seconds
4 beeps
Alarm in progress
RED Flashing rapidly 2-3 seconds
4 beeps
System in Panic Mode
GREEN ON 2-3 seconds
1 beep
Disarmed, Ready to Arm
GREEN Flashing slowly 2-3 seconds
silent
Disarmed, Not Ready to Arm
Single GREEN flash
silent
RF Transmission
OFF
1 second beep
Not Hearing From Panel
GREEN LEDs Flash alternately 8 seconds, then ON 3 seconds
chirp for confirmation
RF6FOB Enrollment
BETA QIG – 02/10/15
RF6FOB
Buttons 1-8 /
Buttons 1-8/
Buttons 1-8/
Buttons 1-8
PLEASE GO TO THE BOTTOM OF THE NEXT PAGE
FOR FCC/IC AGENCY STATEMENTS
BATTERY CAUTION: Risk of fire, explosion and burns. Do not
recharge, disassemble, heat above 212° F (100° C) or incinerate.
Dispose of used batteries promptly. Keep away from children.
FC:
BATTERY
CAUTION
: Risk of fire, explosion and burns. Do not
recharge, disassemble, heat above 212° F (100° C) or incinerate.
Dispose of used batteries promptly. Keep away from children.
SP:
BATTERY
CAUTION
: Risk of fire, explosion and burns. Do not
recharge, disassemble, heat above 212° F (100° C) or incinerate.
Dispose of used batteries promptly. Keep away from children.
PA:
BATTERY CAUTION
: Risk of fire, explosion and burns. Do not
recharge, disassemble, heat above 212° F (100° C) or incinerate.
Dispose of used batteries promptly. Keep away from children.
Specifications:
Battery
: CR2032, DL2032
RF Frequency
: 2.4GHz
Operating Temperature
: 32° to 122° F / 0° – 50° C
Relative Humidity
: 5 – 95%, non-condensing
Dimensions
: 11 mm H x 65.5 mm L x 36 mm W /
0.43” H x 2.58” L x 1.42” W
Approval Listings:
RoHS FCC / IC
ANSI/UL1023; ANSI/UL985 ULC ORD C1023; ULC S545
SIA CP-01 C-Tick
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized
changes or modifications could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules, and RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired
operation.
Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS-210 des Industries Canada. Son fonctionnement est soumis aux conditions
suivantes: (1) Cet appareil ne doit pas causer d’interférences nuisibles. (2) Cet appareil doit accepter toute interférence reçue y compris les interférences
causant une reception indésirable.
RF Exposure Warning – Warning – The antenna(s) used for this device must not be co-located or operating in conjunction with any other
antenna or transmitter except in accordance with FCC multi-transmitter product procedures.
Attention - L'antenne (s) utilisé pour cet appareil ne doit pas être co-localisées ou opérant conjointement avec une autre antenne ou émetteur non conformant
avec les procédures FCC pour les produits à multi-transmetteurs.
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED, FOR DETAILS
REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
This wireless key is intended as a convenience to the user and should not be considered as a life safety device.
For the latest documentation and online support information, please go to: / Pour de l’assistance
en ligne, visitez : / Para recibir soporte en línea, visite: / Para qualquer informação adicional, contacte:
http://www.security.honeywell.com/hsc/resources/MyWebTech/
For the latest U.S. warranty information, please go to www.honeywell.com/security/hsc/resources/wa or
Please contact your local authorized Honeywell representative for product warranty information.
Pour obtenir de l'information sur la garantie de ce produit, veuillez communiquer avec le représentant
autorisé de Honeywell de votre région.
Por favor contacte con su distribuidor Honeywell Security para información sobre la garantía del producto.
Contacte o representante autorizado Honeywell local para obter informações relativas a garantia.
2014 Honeywell International Inc. Honeywell and is a registered trademark of Honeywell International Inc.
All other trademarks are the properties of their respective owners. All rights reserved
Ê800-15960GŠ
P/N 800-15960 01/15 Rev BETA
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
www.honeywell.com/security
MyWebTech Warranty

Navigation menu