Advance Security R38 Car Alarm Receiver User Manual 6945RBUM

Download:
Mirror Download [FCC.gov]
Document ID	404038
Application ID	0QeUPY+CwFq8iCjonc5/8Q==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	7.7kB (96241 bits)
Date Submitted	2004-03-10 00:00:00
Date Available	2004-03-10 00:00:00
Creation Date	2004-03-02 12:59:10
Producing Software	QuarkXPress(tm) 6.0
Document Lastmod	2004-03-09 17:39:54
Document Title	6945RBUM
Document Creator	QuarkXPress(tm) 6.0

4900UM
3/2/04
12:59 PM
Page 1
OWNER’S
MANUAL
Model: 4900/4901
Vehicle Immobilizer
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s authority to operate the equipment.
4900UM
3/2/04
12:59 PM
Page 2
Welcome to the world of Silencer® automotive security. Silencer automotive security products have
been designed to provide the consumer with a product that is technologically superior, providing
years of trouble free operation.
This manual will provide reference for the operation and maintenance of your new Silencer vehicle
immobilizer system.
This system is an automatic device that will become armed every time you leave your vehicle. Once
armed, the Silencer vehicle immobilizer will prevent your vehicle's engine from operating, aiding in the
prevention of vehicle theft.
Take a moment to read this manual so you will be familiar with the operation of your new system.
Valet
On
Disarm
Valet
Off
3-Button Transmitter
1-Button Transmitter
Passive Arming
Once you have turned the ignition key to the "Off" position, the Silencer engine immobilizer will
become armed in 30 seconds. Upon arming, the device will emit 1 chirp sound to indicate it’s
"Armed". If you turn the ignition key back on before the 30 seconds has elapsed, the system will reset
and wait for the ignition key to be turned to the "Off" position again.
Note: This passive arming feature could qualify in some states for an insurance discount. Check with
your insurance agency.
Manual Disarm – 3-Button Transmitter
When you return to your vehicle to start the engine, press the “Disarm” button on the 3-button
transmitter. When the system is disarmed, the device will emit 2 chirps to indicate it’s "Disarmed".
Manual Disarm – 1-Button Transmitter
When you return to your vehicle to start the engine, press the button on the transmitter. When the
system is disarmed, the device will emit 2 chirps to indicate it’s "Disarmed".
4900UM
3/2/04
12:59 PM
Page 3
RF Protection Mode
Each time the system is disarmed using the transmitter, the device will begin a protection mode
countdown. This is a timed secondary protection mode to insure the RF signal that disarmed the
system came from your transmitter. If you do not start your vehicle within the 60 second timer
countdown, your Silencer system will become rearmed and your engine will be disabled.
Emergency Override
There may come a time when it will be necessary to manually disarm your Silencer system without
using your transmitter. This condition occurs if the battery in your transmitter is low, dead or if your
transmitter becomes damaged or lost. In these circumstances, it will be necessary to use your ignition
key to perform an emergency override procedure to get your vehicle operational. Follow this procedure
to manually override your system:
1. Turn on the ignition key for 10 seconds then turn it off.
2. Wait for 10 seconds.
3. Turn on the ignition key for 10 seconds then turn it off.
4. Wait for 10 seconds
5. Turn on the ignition key and the vehicle will start.
Valet Mode
(Only applies if you have a 3-button transmitter)
The valet mode allows you to temporarily turn off the passive arming function, eliminating the need to
give your transmitter to a parking attendant or garage mechanic.
To enter the valet mode, follow this procedure:
1. Press the disarm button on your transmitter to insure the device is disarmed (you will hear 2
beeps from the device).
2. Within 3 seconds of pressing the disarm button, press and release the “Valet On” button 3 times
slowly. The device will emit 3 long beeps to indicate the valet mode "On" condition.
To exit the valet mode, follow this procedure:
1. Press the "Disarm" button on your transmitter (you will not hear any sound).
2. Within 3 seconds of pressing the disarm button, press and release the “Valet Off” button 3 times
slowly. The device will emit 1 long beep to indicate the valet mode is "Off".
System Maintenance
The only maintenance that your Silencer engine immobilizer requires is a periodic check to insure that
all operations are functioning normally. This is also good practice for you to refresh your memory on
“Emergency Override” and “Valet Mode” procedures.
Batteries
The batteries supplied with your remote controls should last over 1 year. Heavy transmitter usage will
shorten battery life. Reduced transmitter range is usually a indication that the batteries are becoming
weak and should be replaced. Transmitters that are not in use should have the batteries removed.
4900UM
3/2/04
12:59 PM
Page 4
Battery Replacement
To replace (or remove for storage) the batteries in your transmitter, follow this procedure:
1. Turn the transmitter over and locate the slot at the edge of the transmitter case.
2. Use a small flathead screwdriver to pry apart the top and bottom case of the transmitter while
keeping the button side facing downward.
3. Once the back is completely removed, press on the button face to remove the entire transmitter
assembly from the case.
4. Separate the transmitter circuit board from the rubber button case and slide the old battery out
of it’s holder.
5. Replace the battery in reverse sequence observing the correct polarity of the battery (+ battery
side should be facing upward).
6. The 3 volt battery for this transmitter is model CR2032. This battery is very common and can be
found in most convenience stores and camera shops.
3 Year Warranty
Your new Silencer ® Security Systems is warranted to be free of defects for 3 years. Silencer ® or its
authorized agents will within 3 years from the date of sale to you, repair or replace said product or
any part thereof, at the option of the Silencer ® or its authorized agents, if said product or part is
found defective in materials or workmanship, when properly connected and operating on the correct
power requirements designated for the specific product. This warranty and Silencer ® or its
authorized agents obligations hereunder do not apply where the product was; damaged while in the
possession of the consumer, subjected to unreasonable or unintended use, not reasonably
maintained, or serviced by anyone other than Silencer ® or its authorized agents, or where the
warning seal on the product is broken or the power and/or plugs are detached from the unit. This
warranty does not cover the cabinet appearance items or accessories used in connection with this
product, or any damage to the products resulting from improper installation, alteration, accident,
misuse, abuse or acts of nature. Silencer ® OR ITS AUTHORIZED AGENTS SHALL NOT BE LIABLE
TO ANYONE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES OR CLAIMS EXCEPT THOSE
ACCORDED BY LAW. NO EXPRESSED WARRANTY OR IMPLIED WARRANTY IS GIVEN EXCEPT
THOSE SET FORTH HEREIN. NO IMPLIED WARRANTY SHALL EXTEND BEYOND 3 YEARS FROM
THE DATE OF SALE. Some states do not allow limitations on how long an implied warranty lasts, and
some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusion may not apply to you. This warranty gives you specific legal rights,
and you may have other rights that vary from state to state. Defective merchandise should be
returned to the original point of purchase or secondly, to 1111 W. Victoria Street, Compton CA
90220. Return Authorization must be obtained before sending, or merchandise may be refused. All
claims concerning your Silencer ® Security System should be referred to your selling dealer. If you
are away from the vicinity of the selling dealer please call (800) 340-3200.
© 2004 Copyright Magnadyne Corp.
3-2-04 Rev. B
4900UM

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Modify Date                     : 2004:03:09 17:39:54+08:00
Create Date                     : 2004:03:02 12:59:10Z
Creator                         : QuarkXPress(tm) 6.0
X Press Private                 : %%DocumentProcessColors: Black.%%EndComments
Page Count                      : 4
About                           : uuid:14617c7e-6c97-11d8-bb81-000a95903604
Producer                        : QuarkXPress(tm) 6.0
Creation Date                   : 2004:03:02 12:59:10Z
Mod Date                        : 2004:03:09 17:39:54+08:00
Creator Tool                    : QuarkXPress(tm) 6.0
Metadata Date                   : 2004:03:09 17:39:54+08:00
Document ID                     : uuid:0de388c0-6c97-11d8-bb81-000a95903604
Format                          : application/pdf
Title                           : 6945RBUM

EXIF Metadata provided by EXIF.tools