Advanced Mobile Payment AMP8200 8 Series Smart POS Terminal User Manual AMP 8200 CE FCC

Users Manual

AMP 8200

FCC Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may

cause undesired operation.

Note: The grantee is not responsible for any changes or modifications not expressly

approved by the party responsible for compliance. Such modifications could void the

user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

- Consult the dealer or an experienced radio/TV technician for help

RF Exposure Statement

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types

Smart POS Terminal (FCC ID: 2AKJB-AMP8200) has also been tested against this SAR

limit. The highest SAR value reported under this standard during product certification

when properly worn on the body is 1.022W/kg. This device was tested for typical body-

worn operations with the back of the handset kept 0cm from the body. To maintain

compliance with FCC RF exposure requirements, use accessories that maintain a 0cm

separation distance between the user's body and the back of the handset. The use of belt

clips, holsters and similar accessories should not contain metallic components in its

assembly. The use of accessories that do not satisfy these requirements may not comply

with FCC RF exposure requirements, and should be avoided.