Aiphone LEM 1 And 3 Master Selective Intercom Instructions 13Instr0901

LEM-instructions LEM-instructions

LEM-3 to the manual 3beef550-2729-46ca-8391-62d8b80324fe

User Manual: Aiphone LEM-1 and LEM-3 Master Selective Intercom Instructions Instructions

Open the PDF directly: View PDF PDF.
Page Count: 4

DownloadAiphone LEM-1 And LEM-3 Master Selective Intercom Instructions LEM-13Instr0901
Open PDF In BrowserView PDF
LEM-1 MANUAL E TH 0901 A

LE Series
MASTER SELECTIVE INTERCOM
Models:

LEM-1
LEM-3

INSTALLATION & OPERATION MANUAL

1 SYSTEM OUTLINE & COMPONENTS
LEM Open Voice Master Selective Intercom System is a single master system with 1- and 3-call master stations.
Works with “LE” style door and inside sub stations.
LE-A/AN

LEM-1

LE-D

2
2
LE-D

LEM-3

2

PS6

LE-A/AN

2
PS6

䡵 Package contents
PS6 : 6V DC power supply.

•
•
•
•

䡵 Components available
• Master stations

LEM master (LEM-1 or LEM-3)
Mounting bracket (LEM-1 only)
Packet of screws
Installation & Operation Manual
• Power supply

• Sub stations

LEM-1,

LEM-3,

LE-A,

LE-AN,

1-call

3-call

w/CALL

w/PRIV.
and call

LE-D,
surfacemount

LE-DA,
flushmount

PS-6D,PS-6M or
SKK-620 in USA

2 NAMES & FEATURES
LEM-1

LEM-3
Speaker/mic.

Speaker/mic.

OFF switch
Sub/door
call-in LED

Tone-CALL button

Directory

TALK (LISTEN)
button

Voice volume
control
Selector button
OFF switch

䡵 Features

TALK (LISTEN) button

Single-master open voice communication
• 1 or 3-call masters
• 2 conductors per sub, homerun
• Voice or tone call
• Desk or wall-mount use
• Handsfree remote reply at sub

–1–

Voice volume
control

3 PRECAUTIONS ON INSTALLATION & WIRING
CAUTION
★ LEM equipment, except for LE-D or LE-DA, is designed for indoor use only.
Do not install outdoors.
★ LEM is an electrical device, which must not be exposed to water or any other liquid.
★ Do not connect AC wires to any terminal on any unit.
★ Do not connect any power source other than specified to terminals +, – on LEM.
Doing so can cause fire or damage the unit.
★ Unplug power supply while making any wire terminations.
★ Do not install LEM equipment in any of the following locations, as it may cause the system to malfunction;
– High or extreme cold temperature areas: under direct sunlight, near equipment that varies in temperature, in
front of air-conditioner, inside a refrigerated area, etc.
– Places subject to moisture or humidity extremes,
– Places subject to environmental conditions, such as oil, dust, chemicals, salt, etc.
– Places subject to constant vibration or impact.
IMPORTANT–Observe the following to prevent fire, injury to people, malfunction, or damage to the equipment.
★
★
★
★
★
★
★
★
★

Do not open the LEM equipment except for wiring. Ask qualified personnel.
Do not change or modify LEM.
Keep moisture away from unit and AC cord.
Keep all DC wiring at least 30cm, 20” away from AC wiring, fluorescent lighting, or dimmer switches. Cross AC wiring
at a 90° angle.
Keep AC cord (power supply) and DC wiring from being pulled or crushed.
LEM is not operable during a power failure.
In areas where broadcasting station antennas are close by, intercom system may be affected by radio frequency
interference.
Make sure wires are connected properly before plugging in DC power supply.
Severe weather conditions, such as lightning storms, may cause damage to LEM equipment. We recommend that
power surge protection be installed as follows: (However, this does not guarantee that no damage will occur.
LEM

• If the power supply has a GROUND
terminal, take it to an earth ground.
In this case, a separate surge
arrester is not necessary.
• When using a power supply that
has no GROUND terminal, install a
surge arrester near the output as
shown.

PS-6D or SKK-620

Red (+)

+
-

White or Black(-)
Install a surge-arrester( discharging
voltage: 100∼180V) at a point
close to the output, taken to earth
ground.

6V DC

Surge-arrester
(Aiphone model:SA-1)

Grounded

䡲

Before actually mounting the LEM equipment, the contents of this Manual must be thoroughly read and understood.

4 WIRING
䡵 Actual terminal locations
LEM-1

LEM-3

+
+
–
–

E

E

1

1

2
3

+, – : 6V DC power supply
E:
Common communication
1 ~ 3: Sub 1 ~ 3 calling and communication

–2–

䡵 Adjusting voice volume
Voice communication volume is adjustable with the switch which is located on right side on LEM-1, and on bottom of front panel
of LEM-3.

䡵 LE sub stations
Do not connect more than one LE station on a numbered terminal, as it causes inferior call tone and voice. Do not parallel two
LEM masters connected to the same sub station.

䡵 Wiring diagrams
• LEM-1 system

• LEM-3 system
LEM-3

LEM-1

1
E

LE sub(any)

NP

LE sub(any)

1
E
–

NP

1

1
E
–

2

1
E
–

E

+
–

3

PS6

1
E
–

+
–

PS6

★ Do not remove the shorting link on LE sub.
PS6 : SKK-620 (+) Red, (–) Black
PS-6D (+) Red, (–) White
PS-6M
Install a power supply within 20m, 66” of LEM master.
NP: Non-polarized

5 MOUNTING
• LEM-1

LEM-3
Single-gang box
Single-gang
box

Mounting
bracket

Connector

83.5mm,
3-5/16"

83.5mm,
3-5/16"

Wall

U
P

Wall

Front Case
Chassis
Cover

Screw(2)

Screw (2)
Push either side
Lift and pull off
夝 For surface wall cable run, pass through opening on top or bottom of back case.

6 OPERATIONS
䡵 Calling sub
On LEM-1, depress both OFF and TALK buttons to ring.
On LEM-3, depress a sub selector button and press CALL button to ring.
Depress TALK button to speak, and release to listen.
Depress OFF switch at conclusion for standby. If not, LEM is not called audibly.

䡵 Receiving
Sub call-in rings with oscillating tone, plus an LED lit 20 sec. on LEM-3.
Momentarily press TALK button to pop up OFF. On LEM-3, first depress a lit selector button. Reply holding down TALK
button. Listen to the sub, releasing.

–3–

䡵 Receiving during communication (on LEM-3)
Call-in from another sub lights an LED only, staying 20 seconds. Upon present communication finished, depress an LED lit
selector button.

䡵 LE sub stations
To call LEM master, simply press CALL button. It rings on LEM as long as the button is depressed. Upon selected, voice
from LEM is heard, reply handsfree toward the unit.

7 TECHNICAL PRECAUTIONS
★ LEM equipment is rated to operate between temperatrues 0°C ~ +40°C (+14°F ~ +104°F).
★ LE-D & LE-DA door stations are weather-resistant, but it is suggested to protect against direct weather. Do not apply caulking
or sealant around door station. The opening allows moisture to dissipate.
★ Do not wash LE-D/DA with direct pressure water.
★ Clean LEM equipment with a soft cloth dampened with neutral household cleanser. Never use an abrasive cleaner or cloth.

8 SPECIFICATIONS
•

Power source:

6V DC, 200mA max.

•

Power supply:

Use a PS-6D,PS-6M or SKK-620 power supply.

•

Communication:

Sub call-in with tone and a lit LED, 20 seconds.
(LED on LEM-3 only)
Press TALK button to transmit, release to listen.
Output: 350mW.

•

Wiring:

2 wires per sub, non-twisted & non-polarized, shielded.

•

Cable specified:

#822202 in USA.

•

Wiring distance:

LEM to LE subs
Diameter
Distance

•

0.65mm"
200m

1.0mm"
480m

22AWG
650’

18AWG
1,570’

Dimensions & weight:
LEM-1: 160H x 132W x 51D (mm).
6-1/4” H x 5-1/4” W x 2” D. 300g (0.66 lbs.) approx.
LEM-3: 180H x 143W x 55D (mm).
7” H x 5-5/8” W x 2-1/4” D. 400g (0.88 lbs.) approx.

WARRANTY
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a
period of one year after delivery to the ultimate user and will repair free of charge or replace at no charge, should it
become defective upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto itself
the sole right to make the final decision whether there is a defect in materials and/or workmanship; and whether or not the
product is within the warranty.
This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in
violation of instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This
warranty does not cover batteries or damage caused by batteries used in connection with the product.
This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by
Aiphone.
Aiphone will not be responsible for any costs incurred involving on site service calls.
AIPHONE CO., LTD., NAGOYA, JAPAN
AIPHONE CORPORATION, BELLEVUE, WA, USA
AIPHONE EUROPE N.V., ANTWERP, BELGIUM

LEM-I(E) 0901A

–4–

Printed in Thailand (E)



Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Producer                        : Acrobat Distiller 6.0.1 (Windows)
Modify Date                     : 2009:04:08 09:16:11-07:00
Create Date                     : 2007:02:02 14:14:46+09:00
Metadata Date                   : 2009:04:08 09:16:11-07:00
Document ID                     : uuid:86aa2bd1-c9d2-4f18-acb7-bf0ac0557af5
Instance ID                     : uuid:657d252a-bb23-4d2b-b004-8cac85d3465c
Format                          : application/pdf
Title                           : untitled
Page Count                      : 4
Page Layout                     : SinglePage
EXIF Metadata provided by EXIF.tools

Navigation menu