Airwave Technologies AWW698RX 5.8GHz Video Sender User Manual Manual
Airwave Technologies Inc 5.8GHz Video Sender Manual
Manual
Photo D.: Photo A: Under no circumstances should you attempt to repair the device yourself, as this would invalidate the warranty. PROBLEM Power Switch 433MHz ID Channel Tack switch (only AWV698C applicable) Transmitter Photo B.: Receiver (Shown above is the antenna direction for application.) Channel Indicator: CH1 ~ CH7 Specification Remote Control Indicator Photo C.: Transmitter: 1. Frequency: 2. Channel: 3. Modulation: Input level: 4. Input port: 5. Antenna: 6. Power supply: 5.725GHz – 5.875GHz 7 selectable channels FM-FM Video - 1 Vp-p (PAL) Audio - 3 Vp-p Video - 75 ohms (PAL) Audio - 10K ohms SCART line cable Built in antenna DC 9V power adapter Receiver: 1. Frequency: 2. Channel: 3. Output port: 4. Antenna: 5. Power supply: 5.725GHz – 5.875GHz 7 selectable channels SCART line cable Built in antenna DC 9V power adapter Impedance: (Receiver) Audio R Audio L Video Power Plug (9V) (Transmitter) plug for IR cable LED (transmitter) Trouble Shooting If a problem occurs, first refer to this information before you take the device for repair. If you are unable to rectify the fault using the information given here, contact your local dealer or service specialist. POSSIBLE CAUSE No The transmission picture/sound channels for the transmission transmitter/receiver do not correspond. The transmission distance is too great. Connecting cable. REMEDY Set the transmission channel on the transmitter/receiver Reduce the distance. Check the EURO-AV plug and the cinch plug. Transmitter or Switch on the receiver not transmitter or switched on. receiver Wrong direction of Adjust the antenna patch antenna to the right position. See photo D. Poor Interference. Move the picture/sound transmitter or quality receiver a few centimeters Change the transmission channel on the transmitter/receiver Microwave units Change channel to and the use of the find better channel so-called ”blue to receive. tooth function” (W LAN) on mobile phones or notebooks. Infrared module. Check the connection and position of the infrared module. Switch this device The remote A wireless control of the transmitter in the off. signal source 433MHz range does not (e.g. a respond. baby-phone) is interfering with the transmission. DOC0000-0269 FCC Notices This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operations. CAUTION: Change or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 2.5 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Encryption : Standard V1.2 (40-bit) User Access : Print, Fill forms, Extract, Assemble, Print high-res Create Date : 2006:11:20 08:03:38Z Modify Date : 2007:04:02 09:23:15+08:00 Page Count : 3 Creation Date : 2006:11:20 08:03:38Z Mod Date : 2007:04:02 09:23:15+08:00 Producer : Acrobat Distiller 5.0 (Windows) Metadata Date : 2007:04:02 09:23:15+08:00 Has XFA : NoEXIF Metadata provided by EXIF.tools