Alcatel Lucent France MO-V2-250MW-DB 9364 Metro Cell Outdoor V2.0 1900/850MHz 250Mw User Manual USERS MANUAL 2

Download:
Mirror Download [FCC.gov]
Document ID	1676022
Application ID	PMkicyIMvYZpis1U+UZ/9Q==
Document Description	USERS MANUAL 2
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	11.58kB (144777 bits)
Date Submitted	2012-04-13 00:00:00
Date Available	2012-10-10 00:00:00
Creation Date	2017-11-01 02:22:04
Producing Software	GPL Ghostscript 9.18
Document Lastmod	2017-11-01 02:22:04
Document Title	USERS MANUAL 2
Document Creator	Microsoft® Office Word 2007

FEDERAL COMMUNICATIONS COMMISSION
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection. This equipment generates, uses and can radiated
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with emission limits.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user‘s authority to operate the equipment.
RF Exposure Information
FCC
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal Communications Commission of the U.S.
Government.
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure
limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal
operation.
IC Regulations:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement."
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This Category II radiocommunication device complies with Industry Canada Standard RSS-310.
Ce dispositif de radiocommunication de catégorie II respecte la norme CNR-310 d’Industrie Canada.
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between
the radiator & your body.
Eurpoean Conformity Statement
Declaration of conformity with Regard to the R & TTE 1999/5/EC and EMC 2004/108/EC
directives
R&TTE Regulation:
In all cases assessment of the final product must be mass against the Essential requirements
of the R&TTE Directive Articles 3.1(a) and (b), safety and EMC respectively, as well as any
relevant Article 3.3 requirements.
The maximum antenna gain for frequency 2100 is 4 dBi.
RoHS Statement
This device conforms to RoHS(Reduction Of Hazardous Substances) European Union
requlations that set maximum concentration limits on hazardous materials used in electrical
and electronic equipment.
This equipment may be operated in:
AT
BE
BG
CH
EE
ES
FI
FR
IT
IS
LI
LT
NO
PL
PT
RO
CY
GB
LU
SE
CZ
GR
LV
SI
DE
HU
MT
SK
DK
IE
NL
TR

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Copy, Extract, Print high-res
Language                        : zh-TW
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Create Date                     : 2011:08:17 16:16:55Z
Creator Tool                    : Microsoft® Office Word 2007
Modify Date                     : 2011:11:07 17:32:19+08:00
Metadata Date                   : 2011:11:07 17:32:19+08:00
Producer                        : Microsoft® Office Word 2007
Format                          : application/pdf
Document ID                     : uuid:ab7ad436-26b4-4dc6-a814-f638fca89800
Instance ID                     : uuid:2276de11-4d1f-4ef8-aee1-c781494b0a30
Page Count                      : 2
Creator                         : Microsoft® Office Word 2007

EXIF Metadata provided by EXIF.tools