Alcatel USA 8000-2U Digital Transmission System Transmitter User Manual User Guide warnings2
Alcatel USA Marketing, Inc. Digital Transmission System Transmitter User Guide warnings2
Contents
- 1. User Guide Warnings
- 2. User Guide Part 1
- 3. User Guide Part 2
- 4. USer guide warnings
USer guide warnings
Issue 1 June 2006 APPLICATIONS 2.1 INTRODUCTION 3EM20188AAAA Applications Section The MDR-8000 family of microwave radios is specifically designed to satisfy the evolving needs of public, private, government, and international networks. Each DS1/E1 radio offers the flexibility of 2, 4, 8, 12, 16 DS1s or E1s to meet the need for low capacity domestic or international systems. Each DS3 radio offers up to three DS3s with equal number of wayside DS1s to meet domestic high capacity system requirements. Each OC3/STM-1 radio offers one or three STS1s with equal number of wayside DS1s or E1s to meet domestic or international Synchronous Optical Network (SONET) system requirements. The MDR-8000E Ethernet radio provides transport for IP/packet data in licensed and unlicensed frequency bands. The radio supports 10baseT, 100baseT, and 1000baseT interface rates with auto-negotiation and can be configured to transport low and high capacity data at RF frequencies in the 2, 4, 5, 6, 7/ 8, and 10/11 GHz bands. The number of channels transmitted and the RF channel bandwidth depend on the capacity keys installed in the transmitter and receiver modules. The modulation formats are 32 or 128 TCM (DS1/E1), 64 QAM (DS3), and 128 TCM (OC3/STM-1). Growth in DS1/E1 system capacity can be performed in service and requires only exchanging capacity keys. Growth from DS1/ E1 to DS3 system capacity is an out-of-service procedure and requires exchanging modules and capacity keys. Changing to OC3/STM-1 system capacity is performed out-of-service and requires exchanging modules, and capacity keys. All radios are available in 1:0 non-standby (NS) and 1:1 hot-standby (HS) and frequency diversity (FD). The HS version allows for troubleshooting and module replacement, on an in-service basis. Space diversity can be added to any of the three basic configurations. In addition to the three basic configurations, the OC3/STM-1 radio is available with a 0:2 dual channel (no protection) equipment configuration and the protected OC3/STM-1 radio is also available in a 2 X 4-fiber or 4-fiber cable configuration. 2.2 TYPICAL USERS Because of unique flexibility in both frequency and capacity, the MDR-8000/i/s can be used for a variety of voice, data, and video applications, for many types of users, some of which are listed as follows: • Personal Communication Systems (PCS) • Cellular Operators • Common Carriers • Alternate Access and Competitive Access Providers (CAP) • Private Networks • Educational Institutions • State, Local, and Federal Government Systems • International Users. 2.3 UNLICENSED RADIO The MDR-8X05U/8X02U (unlicensed) radio provides fast deployment of service with microwave radio No license and small antennas (no FCC requirements) allow immediate turnup. After the license is received, the unlicensed radio can be easily converted to the lower 6 GHz licensed band. 2-5 Issue 1 June 2006 Applications Section 3EM20188AAAA Refer to drawing 3DH031770001BJZZA in Volume 2 for configurations and equipping options. The MDR-8X05U radio operates in the 5725-5850 and 2400-2483.5 Information, Scientific, and Medical (ISM) band in accordance with FCC Part 15.247 of the FCC rules. Any changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. This unlicensed radio, although operating in the same band as a spread spectrum radio, operates using narrower bandwidths than spread spectrum. Advantages, disadvantages, and antenna recommendations for the unlicensed radio follow: 2.3.1 Advantages • • • • • • Fast installation and turnup 2, 4, 8, 16 DS1, DS3, and OC3/STM-1 capacities Field convertible to lower 6 GHz licensed band Field expandable to higher capacities. Common network management with licensed radios. Common spares and training with licensed radios 2.3.2 Disadvantages • • • • No interference protection Operating restrictions 5.725 to 5.850 GHz band/2.4 to 2.4835 GHz Performance could deteriorate due to interference as the frequency band becomes congested. 2.3.3 Antenna Recommendations • Frequency – 5.8 GHz/2.4 GHz • Size and Type – 2, 4, 6, 8, or 10 foot parabolic; 1 or 2 foot flat panel. • Gain and Beamwidth (3 dB) 5.8 GHz 2.4 GHz 2 ft parabolic – 29 dB/6û 2 ft parabolic – 20 dB/13.8û 4 ft parabolic – 35 dB/3û 6 ft parabolic – 38 dB/2û 8 ft parabolic – 41 dB/1.5û 10 ft parabolic – 42.5 dB/1.2û 4 ft parabolic – 27 dB/6.9û 6 ft parabolic – 30.5 dB/4.6û 8 ft parabolic – 33.3 dB/3.5û 10 ft parabolic – 35.2 dB/2.8û Note When using a 1 ft flat panel antenna with a 1 watt (+30 dBm) output power, the antenna must be located in an area that does not allow the general population access to within 5 feet (5.8 Ghz) or 6.5 feet (2.4 Ghz) of the antenna. 5.8 GHz 2.4 GHz 1 ft flat panel – 23 dB/9û 1 ft flat panel – 18 dB/30û 2 ft flat panel – 28 dB/3.5û 2-6
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Page Count : 2 XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6 About : uuid:d0a29de3-70a7-4e52-9541-5d824d11956d Producer : GPL Ghostscript 8.15 Modify Date : 2006:10:17 15:02:25-05:00 Create Date : 2006:10:17 14:13:53Z Creator Tool : PScript5.dll Version 5.2.2 Metadata Date : 2006:10:17 15:02:25-05:00 Document ID : uuid:f25858d1-98cc-4fbc-9303-0f723738a693 Format : application/pdf Title : Microsoft Word - User_Guide_warnings2.rtf Creator : ettaylor Author : ettaylorEXIF Metadata provided by EXIF.tools