Amazon com Services SRBRSBADGE SRBRS Badge Module User Manual

Amazon Robotics LLC SRBRS Badge Module Users Manual

User Manual

User’s Manual The User’s Manual shall contain the following information. End Product Labeling and Manual Requirements The following information must be visible and displayed on the end product.  “FCC ID: 2AEZR-SRBRSBADGE”  “IC: 10244A-SRBRSBADGE”  ”This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.” “Le présent appareil est conforme à la partie 15 des règles de la FCC et CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.” Note: If it is difficult to print the above statement on the end product or host device due to size, then the statement shall be printed in the end product/host device user’s manual. The end product/host device user’s manual shall contain the following statement cautioning the user that;  “Changes or modifications not expressly approved by Amazon Robotics LLC could void the user’s authority to operate the equipment.”  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. RF Exposure Requirements “WARNING! FCC and IC Radiation Exposure Statement: This portable equipment with its antenna complies with FCC’s and IC’s RF radiation exposure limits set forth for an uncontrolled environment. To maintain compliance follow the instructions below: 1. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2. Avoid direct contact to the antenna, or keep contact to a minimum while using this equipment.”

Navigation menu