Amiigo C1001 Wavelet Charger User Manual

Amiigo Inc. Wavelet Charger

User Manual

Charging the Wristband and PodBefore using your devices you will need to fully charge them and update their firmware.Plug in your charger to a powered USB port. The LEDs should light up white. Place the Wristband in the slot towards the back of the charger as shown in the illustration below, and the Pod in the slot towards the front of the charger with the Wavelet logo facing UP. The white lights on the charger will turn orange next to each device when charging properly. Each LED will blink or remain white if not charging properly or if the device is not placed properly. Your devices requires about 90 minutes to fully charge their lithium-polymer batteries. Once fully charged, the LEDs on the charger will change back to white. It is recommended to fully charge your device as you finish the rest of the setup process. With normal use, your Wristband should last about four days on a single charge, while your Pod should last about 5 days, both depending on use.NOT CHARGINGCHARGING3
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment。 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. FCC ID: 2AKLD-C1001 Amiigo Inc. Model name: Wavelet Charger Model No.: C1001 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Navigation menu