Aqua Ventus HIFI-PWR9XX Ultimate Waterproof HiFI Stereo Sound System User Manual
Aqua Ventus Ltd. Ultimate Waterproof HiFI Stereo Sound System Users Manual
Users Manual
When used in the directed manner, this unit has been designed and manufactured to ensure
your personal safety. However, improper use can result in potential electrical shock or re
hazards. Please read all safety and operating instructions carefully before installation and use,
and keep these instructions handy for future reference. Take special note of all warnings listed in
these instructions and on the unit.
1. Ventilation
The unit should be situated so that its location or position does not interfere with its proper
ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that
may block the ventilation openings. The ventilation should not be impeded by covering
the ventilation openings with items, such as newspapers, table-cloths, curtains, etc. Also,
it should not be placed in a built-in installation, such as a bookcase or cabinet, which may
impede the ow of air through the ventilation openings; minimum distances 20 cm around
the apparatus for sufcient ventilations.
2. Heat & Flame
The unit should be located far away from heat sources such as radiators, heat registers, stoves
or other appliances (including ampliers) that produce heat.
No open ame sources, such as lighted candles, should be placed on the apparatus.
3. Power Source
The unit should be connected to a power supply only of the type described in the operating
instructions or as marked on the appliance. Where the power adaptor is used as the discon-
nect device, the disconnect device shall remain readily operable.
4. Power Cord Protection
Power supply cords should be routed so that they are not likely to be walked on or pinched
by items placed upon or against them. It is always best to have a clear area from where the
cord exits the unit to where it is plugged into an AC outlet. The mains plug of apparatus
should not be obstructed OR should be easily accessed during intended use.
5. Cleaning
The unit should be cleaned only as recommended. See the section “Care and Maintenance”
of this manual for cleaning instructions.
6. Object and Liquid Entry
Care should be taken so that objects do not fall and liquids are not spilled into any open-
ings or vents located on the unit. It shall not be exposed to dripping or splashing and that no
objects lled with liquids, such as vases, shall be placed on the apparatus.
7. Attachments
Do not use attachments no recommended by the product manufacturer.
8. Lightning and Power Surge Protection
Unplug the unit from the wall outlet and disconnect the periods of time. This will prevent
damage to the product due to lightning and power-line surges.
9. Overloading
Do not overload wall outlets, extension cords, or integral convenience receptacles as this
can result in a risk of re of electric shock.
10. Damage Requiring Service
This unit should be serviced by qualied service personnel when:
A. The power supply cord or plug has been damaged.
B. Objects have fallen into or liquid has been spilled into the enclosure.
C. The unit has been dropped or the enclosure damaged.
D. The unit exhibits a marked change in performance or does not operate normally.
Important Safety Instructions
11. Periods of Nonuse
If the unit is to be left unused for an extended period of time, such as a month or longer, the
power cord should be unplugged from the unit to prevent damage or corrosion.
12. Servicing
The user should not attempt to service the unit beyond those methods described in the user’s
operating instructions. Service methods not covered in the operating instructions should be
referred to qualied service personnel. Contact Pyle Technical Support for any issues:
support@pyleaudio.com
13. Environment
Attention: Do not dispose of batteries improperly pay attention to the environmental aspects
of battery disposal and the use of unit in moderate climates.
Thank you for purchasing the Bluetooth Floating Speaker.
This model incorporates following features:
- Playback Apple device (iPad /iPhone/iPod Touch) and Android OS smart phone music
through Bluetooth technology.
- Open air operating distance of up to 32 feet.
- Water proof Speaker
- LED Indicator
- USB charging function
iPad, iPhone and iPod touch are trademarks of Apple Inc., registered in the U.S. and other
countries.
Smart phone, iPad, iPhone, iPod touch are not included.
Features
Location of Controls
Main Unit
Front View Bottom View
1. LED indicator - Power off mode: LED indicator is off.
- Operating mode: Blue light LED indicates Bluetooth
mode.
- Red light LED indicates charging mode.
2. Standby / button - While Power switch is set at ON position:
Press and hold this button until a short melody sounds
entering Bluetooth mode.
Press and hold this button to turn the unit into standby
mode.
- In Bluetooth mode: Press the button to Play / Pause the
mobile device music.
3. / button
- In Bluetooth mode: Skip tracks Backward / Forward.
4. VOL +/- button - Adjust the output volume level up and down.
5. Speakers
6. Bottom cap
7. Power ON/OFF switch
8. Micro USB connector For charging battery
9. Built-In Rechargeable Battery
Installation
Battery Charging:
The unit incorporated a built-in rechargeable battery. A battery compartment located at bottom
of the unit.
(1) Unscrew the Bottom cap counter-clockwise and open it.
(2) Connect the micro USB plug of the USB cable to the micro USB connector of the unit.
Red indicator lights up when charging the unit, light turns off when it’s full charged.
Note:
Battery Life: 4 Hours (Charge Time: 8 Hours)
Please use standard DC 5V 1000mA adapter and supplied USB cable to charge. Or, connect
USB cable to computer to charge. If the adapter power rating is too small, it may cause the unit
not to be fully charged or have short battery running time.
Warnings:
- Battery shall not be exposed to excessive heat such as sunshine, re or the like.
- Be sure that the battery is installed correctly. Wrong polarity may damage the unit.
- Only battery of the same or equivalent type as recommend are to be used.
- If the unit is not to be used for an extended period of time, remove the battery.
- Do not dispose of battery in re, battery may explode or leak.
- Danger of explosion if battery is incorrectly replaced.
Caution:
This set-up is for charging the rechargeable battery of the Speaker only.
Do not operate the Speaker with this set-up near Water and Moisture environment.
Bluetooth Operation
Bluetooth pairing/connection :
1. Slide the Power switch to ON position.
2. Press and hold the Standby button until a short melody sounds.
3. The unit will search nearby Bluetooth device and the Blue LED indicator will blink.
From the Android smart phone or Apple device (iPad/iPhone/iPod touch), turn on its Blue-
tooth function. Search for the device name (PWR90D) on Android smart phone or Apple
device, select, pair and connect. The blue LED indicator of the unit lights steadily.
When the unit is turned on from standby mode, it will automatically search and connect the
device last connected, no need to re-scan and pair.
Note: Standby mode ----- Blue LED lights off.
Searching last connected mobile device ----- Blue LED blinks slowly.
Searching other mobile device ----- Blue LED blinks fast.
Bluetooth mobile device connected ----- Blue LED lights steadily.
Playback Apple device (iPad/iPhone/iPod touch) or Android smart phone music :
4. Playback your Apple device or Android smart phone music.
5. You may adjust both the volume control of your mobile device and the volume control of this
unit to nd the most desirable volume setting.
6. (a) You may tap the / button from the mobile device or press the button from the
main unit to Play / Pause the mobile device music.
(b) Press the / button from the unit to skip tracks forward / backward.
7. After listening the music, press and hold the Standby button which turns the unit into
standby mode.
Energy Saving Note :
In Bluetooth mode, if the Bluetooth communication link disconnected (the main unit) for
around 5 minutes, the unit will turn into standby mode automatically.
Care and Maintenance
- Do not subject the unit to excessive force, shock, dust or extreme temperature.
- Do not tamper the internal components of the unit.
- Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
- Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
- Keep your unit away from heating appliances and sources of electrical noise such as
uorescent lamps or motors.
Specications
Output power: 1.5W x 4
Battery: built-in Lithium battery
Charge power: DC 5V 500mA
Bluetooth range: > 10M (The distance shall be different in different environment
or with different Bluetooth device)
Compliance with FCC Regulations
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE SET ARE SUBJECT TO CHANGE
WITHOUT PRIOR NOTICE.
www.pyleaudio.com
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
