User Manual
UMAWAC24UR Rev1.0
September 1, 2016
AWAC24UR User Manual
DSAWAC24UR -DSSS USB Radio Dongle
2.4GHz DSSS USB Radio Dongle AWAC24UR
User Manual
Artaflex Inc. UMAWAC24UR Rev 1.0
174 West Beaver Creek Rd.
Richmond Hill, Ontario, Canada
L4B1B4 Page 2 of 4 http://www.artaflexmodules.com
905-479-0148
Wireless USB Radio Dongle Installation
1. Plug in the Artaflex USB dongle to any USB port, you will see the following message .
2. Once asked for the drivers please select “Install from a specific location” then Browse and select the
USB driver.
3. When asked for device selection please select “Artaflex USB to RF dongle” from the list
2.4GHz DSSS USB Radio Dongle AWAC24UR
User Manual
Artaflex Inc. UMAWAC24UR Rev 1.0
174 West Beaver Creek Rd.
Richmond Hill, Ontario, Canada
L4B1B4 Page 4 of 4 http://www.artaflexmodules.com
905-479-0148
FCC Statement
One of the bottlenecks that many product developers encounter in incorporating any radio
communication device is facing the legal aspect of qualifying the products and going to market
without encountering legal problems. The Telecommunication Certification Body (TCB)
authorization process in the United States offers manufacturers more than one approval body. The
TCB authorization process certifies devices in accordance with FCC rules and policies. The
performance of the Artaflex AWAC24UR radio is measured according to the requirements of FCC
rules. The major applicable FCC regulations are described in Section 15.247 (a) to (d).
This equipment has been tested and found to comply with the limits for a Class B digital device,
Pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Consult the dealer or an experienced radio/TV technician for help
Any changes or modification not expressly approved by the party responsible for compliance
could void the user's authority to operate the device. Where shielded interface cables have
been provided with the product or specified additional components or accessories elsewhere
defined to be used with the installation of the product, they must be used in order to ensure
compliance with FCC regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.