Aruba Networks APIN0304305 Wireless Access Point User Manual 300 Series RCSI Rev02

Aruba Networks, Inc. Wireless Access Point 300 Series RCSI Rev02

Contents

User Manual Safety Guide

Aruba 300 Series Wireless Access Point Regulatory Compliance and Safety Information Guide0511891-02 | September 2016 1IntroductionThis document contains domestic and international regulatory compliance and safety information for 300 Series access points. To ensure that this device complies with the regulatory standards for your region, please refer to the sections below.Electrical and Environmental SpecificationsRegulatory InformationProper Disposal of Aruba EquipmentElectrical and Environmental SpecificationsFor additional specifications on this product, please refer to the product data sheet at www.arubanetworks.com/safety_addendum.ElectricalEthernet:One 100/1000 Base-T auto-sensing Ethernet RJ45 interfacePower over Ethernet IEEE 802.3at 56VDC (nominal) and 802.3af 48VDC (nominal).Power:Maximum (worst-case) power consumption: 13.5W (802.3af PoE) or 12W (DC)Excludes power consumed by external USB device (and internal overhead); this could add up to 6W (PoE) or 5.5W (DC) for 5W/1A USB deviceDirect DC source: 12Vdc nominal, +/- 5%Power over Ethernet (PoE): 802.3at and 802.3af complaint sourceConnect only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources.EnvironmentalOperating:Temperature: 0°C to +50°C (+32°F to +122°F)Humidity: 5% to 93% non-condensingStorage and transport:Temperature: -40°C to +70°C (40°F to +158°F)Regulatory InformationThe following regulatory model names apply to the 300 Series access points:AP-304/IAP-304: APIN0304AP-305/IAP-305: APIN0305All Aruba access points should be professionally installed by an Aruba Certified Mobility Professional (ACMP). The installer is responsible for ensuring that grounding is available and meets applicable national and electrical codes.Tous les points d'accès Aruba doivent impérativement être installés par un professionnel agréé. Ce dernier doit s'assurer que l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques nationaux en vigueur.If a power adapter other than the Aruba-approved adapter is used in the US or Canada, it should be NRTL listed, with an output rated 12Vdc, minimum 2A, marked “LPS” and “Class 2”, and suitable for plugging into a standard power receptacle in the US and Canada.

Navigation menu