Attenti NTT-830 Nurse Tracking Tag User Manual Staff Card V00
3M Residential Monitoring, Inc. Nurse Tracking Tag Staff Card V00
Attenti >
Users Manual
3M Resident Monitoring 7170 W. Donges Bay Road Toll Free: 800-606-0661
Mequon, WI 35092 Office: 414-358-8200
Fax: 414-358-8100
www.3m.com/residentmonitoring
Copyright 2012 all rights reserved
This document contains information that is proprietary to Attenti Ltd. No part of this publication may be reproduced in any
form whatsoever without prior written approval by Attenti.
Staff Card
USER MANUAL
NTT-830
Nurse Tracking Tag
3M Resident Monitoring
Staff Card User Manual
Page: 2 of 5
TABLE OF CONTENTS
1
Foreword............................................................................................................................................................ 3
2
Product manual ................................................................................................................................................. 3
2.1
Tracking Tag ........................................................................................................................................... 3
2.1.1
Deactivated mode....................................................................................................................... 3
2.1.2
Reset (Standby) Mode ............................................................................................................... 3
2.1.3
Active Mode ................................................................................................................................ 3
2.2
Summary of SC Tracking Modes ............................................................................................................ 4
2.3
Low Battery ............................................................................................................................................. 4
3
FCC Notices ...................................................................................................................................................... 5
3M Resident Monitoring
Staff Card User Manual
Page: 3 of 5
1 FOREWORD
The RFID Staff Card is a device designed to be allocated to nurses in the area monitored by the AMS
system. The tag contains both a passive RFID circuit as well as an active transmission circuit, allowing the
system to capture when and which staff responded to a nurse call event.
2 PRODUCT MANUAL
2.1 Tracking Tag
The SC will have 3 main stages:
• Deactivated mode
• Reset (Standby) Mode
• Active Mode
2.1.1 Deactivated mode
When deactivated, the SC shall not send any sanity transmissions nor shall it monitor motion. The SC shall leave
the factory in this mode.
Active/Rest Deactivated
• Press and hold down the SC's button for 5 seconds; at the end of the 5 seconds, the LED shall be lit
(steady LED) for 5 seconds.
• While the LED is lit, press the button three times; the LED flashes for 3 seconds to indicate that the SC is
about to shut down.
OR
• After 12 hours without motion, the SC shall automatically deactivate.
Note: Before the SC is deactivated, it shall send a transmission to the AMS to indicate that it has been
manually deactivated (as opposed to destroyed or lost).
2.1.2 Reset (Standby) Mode
In Rest mode, the SC shall transmit once every 15 minutes for a period of 1 hour. After 1 hour, the SC shall
transmit once every hour.
Deactivated Rest Mode:
• Press and hold down the button for 5 seconds
Active Rest Mode
• No motion detected by the SC for 2 minutes.
2.1.3 Active Mode
During Active mode, the device shall transmit a signal once every 18 – 22 seconds.
Rest Active Mode
• Motion is detected by the SC.
3M Resident Monitoring
2.2 Summary of
SC Tracking Modes
Figure
SC Status
Low battery
Deactivated → Rest Mode
Rest/Active Mode → Deactivated
2.3 Low Battery
The SC shall send a "Low Battery" signal with every transmission when the battery has approximately (but no
less than) 2 weeks until the transmitter is rendered non
When a "Low Battery" conditi
on is present, the Low Battery LED indicator shall flash once every 10 seconds.
3M Resident Monitoring
Staff Card
User Manual
Page: 4 of 5
SC Tracking Modes
Figure
1: Transition between Modes
LED Indication
Flashes once every 10 seconds
On while
button is pressed, flashing for 3 seconds to indicate that
activation is successful.
On while
the button is pressed, flashing for 3 seconds to indic
deactivation is successful.
The SC shall send a "Low Battery" signal with every transmission when the battery has approximately (but no
less than) 2 weeks until the transmitter is rendered non
-functional.
on is present, the Low Battery LED indicator shall flash once every 10 seconds.
User Manual
button is pressed, flashing for 3 seconds to indicate that
the button is pressed, flashing for 3 seconds to indic
ate that
The SC shall send a "Low Battery" signal with every transmission when the battery has approximately (but no
on is present, the Low Battery LED indicator shall flash once every 10 seconds.
3M Resident Monitoring
Staff Card User Manual
Page: 5 of 5
3 FCC NOTICES
This note is applicable to the American Staff Card
NOTE
The Staff Card complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This device has been tested and found to comply with the limits of the Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This device generates, uses and can
radiate radio frequency energy and, if installed and used in accordance with the instruction, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this device does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to correct the interference by one or more of the following
measures
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Any changes or modifications not expressly approved by the grantee of this device could void
the user’s authority to operate the equipment.
For Customer Support contact
:
3M Resident Monitoring.
Toll Free 1-800-606-0661
Fax +1-414-358-8100
Web: www.3M.com/residentmonitoring