Attenti TRX900F4 Tracking Bracelet Unit User Manual
3M Electronic Monitoring, Inc. Tracking Bracelet Unit
Attenti >
User Manual
Installation Manual for bracelet
TRX900F-4
July 2010
2
Installation Manual for bracelet unit TRX900F-4
Bracelet
To Attach the Bracelet
Match the Bracelet serial number on the Bracelet case to the number on the Bracelet serial
number in the hardware list in PCE. The ankle transmitter and strap will be shipped
unattached. You must insert one end of the strap into the transmitter and push the locking
pins into place. Make sure that the locking pins are flush with the case. Measure the strap to
the offender’s leg and cut the strap to fit around the offender’s ankle. You should size the
strap so that it allows approximately ¼ inch of space between the offender’s leg and the strap
to ensure comfort.
Once you have the strap attached, push the locking pin through the holes on the bracelet and
into the strap until it locks into place
3
Make sure the locking pin is pushed far enough so that the top of the pin is flush with the
bracelet case
To Remove the Bracelet
Cut the strap
Using the screwdriver provided, turn the right locking pin counter clockwise and the left
locking pin clockwise to remove
Lift each side of the pin up from the strap and remove. Slide both ends of the strap out of its
channel. Dispose of the strap
Clean the bracelet with mild detergent. Rinse, dry, and return to your inventory.
4
FCC Notices
The ankle transmitter TRX-900F-4 complies with Part 15 of the FCC Rules. Operation is
subject to the following conditions:
1) This device may not cause harmful interference and
2) This device must accept any interference received, including interference that may cause
undesired operation.
3)
Changes or modifications not expressly approved by Elmo Tech Ltd could void the
user’s authority to operate the equipment
.