Audio Partnership PLC MGFM-011 Bluetooth Speaker User Manual Manual
Audio Partnership PLC Bluetooth Speaker Manual
Contents
- 1. user manual
- 2. safety instructions
user manual
Press the button to select the
Aux input.
User’s Manual
To talk to us, call +44 (0)20 3514 1521 (UK Local) or 1 8773578204 (USA)
Portable Bluetooth/FM Speaker
There is an Aux input on the rear of
the unit that allows any analogue
device to be connected.
Aux input
Extend the FM aerial for best reception.
To switch to the FM Radio press one of the preset buttons 1-3.
Press and hold the or buttons to scan for an available station
(a short press will change the frequency step by step).
Storing and using FM presets
Pressing and holding preset buttons 1-3 will store
the current radio station.
A short press on buttons 1-3 will recall the stored station.
1. Touch the area of your NFC device
against the logo on top of Go Radio.
2. Go Radio will enter automatic pairing
mode and ‘Go Radio’should appear on your
device.
1. Press and hold the button to enter Bluetooth
pairing mode
2. Enable Bluetooth connectivity on your Bluetooth
device (eg. phone, tablet etc) and pair with the Go
Radio (you may need to consult your phone or tablet
operating instructions).
To enjoy Bluetooth audio, you must first ensure
that the Go Radio is connected to mains power or
its battery is charged.
Then pair the Go Radio with your Bluetooth
enabled device.
1
3
Pairing a second device
Radio
Connect the charging adaptor to the Go Radio and charge for
4 hours before first use.
The charging LED will indicate Orange whilst charging
and Green when fully charged.
Press and hold the power button on the top of the unit
for one second to turn it on.
1
2
Battery Safety
Auto power down
To save power, your Go Radio will automatically turn off
after 30 minutes if no music is playing. Press the power
button to turn the Go Radio back on.
Low battery warning
A flashing Red LED indicates that the battery is too low
and the Go Radio will enter a standby mode where no
music can be played. This LED will continue flashing for
30 minutes after which the Go Radio will turn off.
USB Charging
The Go Radio can be used to charge compatible mobile
devices.If the charging adaptor is not connected this will
drain the battery.
Your Go Radio contains a high performance battery and charging
system that is designed to work in temperatures that do not
exceed 50°C (122°F). Leaving this product in an automobile
where temperatures may exceed this limit may result in
permanent battery damage, fire or explosion. Do not leave your
product in any location where temperatures may exceed this limit.
If the Go Radio is not used for a long time, please recharge the
battery every two months to maintain the battery in optimal
condition.
Top tips
Press the button to select the Bluetooth input.
Bluetooth set-up
Successful pairing will be signalled by a ‘beep’ from the
unit and the LED will turn solid blue.
Pairing Your Device Using NFC
Pairing Your Device Manually
To pair a different device, press and hold the button to
enter pairing mode and pair your Bluetooth device as
described in the Bluetooth instructions.
2
OR
NFC