Authinx VT36A VGA Video Sender User Manual Exhibit D users manual per 2 1033 b 3

Authinx Inc. VGA Video Sender Exhibit D users manual per 2 1033 b 3

Exhibit D users manual per 2 1033 b 3

OWNER'S MANUALVGA Video SenderMODEL VK60A(INCLUDES VT36A SENDER AND VR30A RECEIVER)VT36AVR30A
32FCC CAUTIONTHIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:(1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDINGINTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.This equipment generates and uses radio frequency energy, and if not installed andused properly, that is, in strict accordance with the manufacturers instructions, it maycause interference to radio and television reception. It has been type tested and foundto comply with the limits for remote control devices in accordance with thespecifications in Sub-Parts B and C of Part 15 of FCC Rules, which are designed toprovide reasonable protection against such interference in a residential installation.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause interference to radio or television reception,which can be determined by unplugging the equipment, try to correct the interferenceby one or more of the following measures.• Reorient the antenna of the radio/TV experiencing the interference.• Relocate the equipment with respect to the radio/TV.• Move the equipment away from the radio/TV.• Plug the equipment into an outlet on a different electrical circuit from the radio/TVexperiencing the interference.• If necessary, consult your local Dealer for additional suggestions.NOTE: Modifications to this product will void the user's authority to operate thisequipment. INTRODUCTION Your Wireless Big Picture VGA Video Sender kit consists of a Senderbase unit which connects to the audio out jack and the VGA outputon your PC, and a Receiver unit which you connect to your TV. TheSender converts the audio signal from your PC's sound card, and theVGA video from your PC's video card into a radio frequency (RF)signal and transmits it (even through walls) to the Receiver unit. TheReceiver converts the signals back to their original form and passesthem to your TV.WARNING:To reduce the risk of fire or electric shock, do not expose this productto rain or moisture.SYSTEM REQUIREMENTS To use the Big Picture system your PC must have a serial port, a VGAout port (that normally connects to your monitor) and a sound cardwith mono or stereo output.
54SENDER(TOP VIEW)RECEIVER(BOTTOM VIEW)2.4 GHzChannel Switch2.4 GHzChannel Switch CONTROLS AND CONNECTIONS SENDER(SIDEVIEW)VGA InCONTENTS CONTROLS AND CONNECTIONS.................................................5SENDER..........................................................................6RECEIVER ........................................................................7BEFORE YOU START .................................................................8CONNECTING UP..................................................................9HOOKING UP THE SENDER....................................................9HOOKING UP THE RECEIVER.................................................10FINE TUNING YOUR SYSTEM....................................................12TROUBLESHOOTING ..............................................................13Serial portconnector
76RECEIVER2.4 GHzVideoAntennaTV OutputConnectorA/V InputJacksPower SupplyJack2.4 GHz ChannelSwitch(on bottom)TV ChannelSwitch(on bottom) ON-OFFSwitch(on side)SENDER310 MHz Antenna foruse with UR81A remoteAudio InputJacksPower SupplyJack2.4 GHzVideoAntenna ON-OFFSwitch(on side)2.4 GHz ChannelSwitchSerial portconnector
98 CONNECTING UP HOOKING UP THE VGA SENDER1. Connect the jack on the audio cable (supplied) to the audio outjack on your PC sound card.2. Connect the red RCA plug to the socket labelled AUDIO RIGHTand the white RCA plug to the jack labeled AUDIO LEFT on theVGA Video Sender.3. Connect the VGA cables as show below so that the VGA out fromyour PC connects to the VGA input on the VT36A and then alsopasses to the VGA input on your monitor.4. Connect the serial port connector to your PC's serial port.5. Set the channel switch (on the TOP of the unit) to channel A (to theRIGHT).6. Plug the VGA Video Sender's Power Supply (the smaller of thetwo power supplies) into a convenient 120 volt wall outlet andplug its jack into the VGA Video Sender.7. Position the VGA Video Sender in a convenient location andorient the antenna so that the flat side points in the direction of theroom where you will be installing the Video Receiver.PBefore you start installing your Big Picture System it is recommendedthat you read this entire owner's manual. This will familiarize youwith the basic hardware installation. Then install the hardware. Youwill then be able to see a picture from your PC on our TV screen. Youcan then visit www.x10.com/software and download the "Boom"program there, which will give you control over what is sent fromyour PC to your TV.BEFORE YOU STARTSerial port connecter
1110IF YOUR SECOND TV IS ALREADY HOOKED UP TO A DBS RECEIVER OROTHER A/V DEVICEIf your DBS Receiver or other A/Vcomponent is connected to the TV usingA/V cables, you can connect the VideoReceiver to the free LINE IN jacks onthe component. If there are no LINE INjacks, you will need to use a TVantenna splitter as described earlier.HOOKING UP THE AUDIO RECEIVER1. Connect a set of Audio/Video cables to the A/V OUT jacks ofyour Video Receiver. Connect the other end to your secondary TV.2. Plug the Video Receiver's Power Supply (the larger of the twopower supplies) into a 120 volt wall outlet and plug its jack intothe Video Receiver.3. Position the Video Receiver in a convenient location such as ontop of the TV and orient the antenna so that the flat side points inthe direction of the room where you set up the Video Sender.IF YOUR TV DOES NOT HAVE A/V CONNECTORSYou can use the suppliedcoaxial cable to connect theTV OUT socket on the VideoReceiver to the Antennainput on your TV. If youalready have an antennaconnected to your TV, youwill need to use a TVantenna splitter.Set your TV and the TVChannel switch on theVideo Receiver (on bottom)to the same channel (3 or 4).
1312FINE TUNING YOUR SYSTEM The Wireless VGA Video Sender usually works best with the flat facesof the antennas on the Sender and Receiver units facing each other(see diagram below). Sometimes, however, reflections and othereffects in your home may affect the signal so that some adjustment ofeither the Sender or Receiver antenna might be necessary to get thebest the signal.TROUBLESHOOTINGIF YOU ARE NOT GETTING ANY AUDIO OR VIDEO AT ALL FROM THEVR30A•Check that the CHANNEL slide switch (labeled A, B, C, D) on bothunits is set to the same letter.•Check that both the transmitter and receiver's power supplies areplugged in. Check that the ON/OFF switch on the transmitter andreceiver are ON.IF THE SOUND OR VIDEO IS POOR, OR THERE IS INTERFERENCE•Try changing the channel on both units. Do this by adjusting theCHANNEL slide switch on each unit to any position (A, B, C, orD).•Make sure both units are set to the same letter. Try repositioningthe antenna on each unit.
12 MONTH LIMITED WARRANTYX10.COM A DIV. OF X10 WIRELESS TECHNOLOGY, INC. (X10)WARRANTS ITS PRODUCTS TO BE FREE FROM DEFECTIVE MATERIAL ANDWORKMANSHIP FOR A PERIOD OF ONE (1) YEAR FROM THE ORIGINALDATE OF PURCHASE AT RETAIL. X10 AGREES TO REPAIR OR REPLACE, ATITS SOLE DISCRETION, A DEFECTIVE X10 PRODUCT IF RETURNED TO X10WITHIN THE WARRANTY PERIOD AND WITH PROOF OF PURCHASE.IF SERVICE IS REQUIRED UNDER THIS WARRANTY:1. CALL 1-800-675-3044, OR VISIT WWW.X10.COM, OR E-MAILSALES@X10.COM TO OBTAIN A RETURN AUTHORIZATION (RA)NUMBER.2. RETURN THE DEFECTIVE UNIT POSTAGE PREPAID TO THE ADDRESSON BACK.3. ENCLOSE A CHECK FOR $4.00 TO COVER HANDLING AND RETURNPOSTAGE.4. ENCLOSE A DATED PROOF OF PURCHASE.5. X10 IS NOT RESPONSIBLE FOR SHIPPING DAMAGE. UNITS TO BERETURNED SHOULD BE PACKED CAREFULLY.THIS WARRANTY DOES NOT EXTEND TO ANY X10 PRODUCTS WHICHHAVE BEEN SUBJECT TO MISUSE, NEGLECT, ACCIDENT, INCORRECTWIRING OR TO USE IN VIOLATION OF OPERATING INSTRUCTIONSFURNISHED BY US, NOR EXTEND TO ANY UNITS ALTERED OR REPAIREDFOR WARRANTY DEFECT BY ANYONE OTHER THAN X10. THISWARRANTY DOES NOT COVER ANY INCIDENTAL OR CONSEQUENTIALDAMAGES AND IS IN LIEU OF ALL OTHER WARRANTIES EXPRESSED ORIMPLIED AND NO REPRESENTATIVE OR PERSON IS AUTHORIZED TOASSUME FOR US ANY OTHER LIABILITY IN CONNECTION WITH THESALE OF OUR PRODUCTS.SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG ANIMPLIED WARRANTY LASTS, AND/OR THE EXCLUSION OR LIMITATIONOF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVELIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO THE ORIGINALCUSTOMER. THIS WARRANTY GIVES YOU SPECIFIC RIGHTS AND YOUMAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.NOTES
X10.com, a division of X10 Wireless Technology, Inc.(Returns Depot), 3824 North 5th St., Suite C,North Las Vegas, NV 89030VK60A-04/01

Navigation menu