Authinx WR10A Wrist Watch Emergency Call Button Transmitter User Manual WR10A inst pm6

Authinx Inc. Wrist Watch Emergency Call Button Transmitter WR10A inst pm6

Users Manual

InstallationThe WR10A comes with a CR2016 Lithium 3V batteryalready installed.1. Set the INSTALL/RUN switch on the Console toINSTALL.2. Press the face of the WR10A and hold for 2 seconds.The Console emits a tone.3. Set the Console's slide switch to RUN.4. To set up additional WR10As (up to eight), repeatabove steps.Note: If you do not hear a tone, remove the battery andthen press down on the face of the WR10A for 2 seconds.Refit the battery and press the face again for 2 seconds toinitialize the WR10A. You can now install the WR10A asdescribed above.Wrist Watch Emergency Call Button, Model WR10ASet Up and Operating InstructionsX-10 (USA) Inc., 91 Ruckman Rd., Closter, NJ 07624.  http://www.x10.comWR10A-998DR1. Set the Console’s slide switch to RUN.2. Press the face of the WR10A and hold for 2 seconds. Ifthe system trips, the Console recognized the WR10Aand no further action is necessary. Press the face of theWR10A twice quickly to stop the alarm.If the system did not trip:1. Set the Console’s slide switch to INSTALL.2. Press the face of the WR10A and hold for 2 seconds.The WR10A transmits a random code to the console.The Console acknowledges this with a beep and logsin the WR10A.2. Set the Console’s slide switch to RUN.X-10 (USA) INC. LIMITED 1-YEAR WARRANTYX-10 (USA) Inc. warrants X-10 products to be free fromdefective material and workmanship for a period of one (1)year from the original date of purchase at retail. X-10(USA) Inc. agrees to repair or replace, at it’s sole discretion,a defective X-10 product if returned to X-10 (USA) Inc.within the warranty period and with proof of purchase.If service is required under this warranty:1. Return the defective unit postage prepaid to X-10(USA) Inc. at the address below.2. Enclose a check for $4.00 to cover postage andhandling.3. Enclose a dated proof of purchase.4. X-10 is not responsible for shipping damage.F.C.C. CAUTION - THIS DEVICE COMPLIES WITHPART 15 OF  THE FCC RULES. OPERATION ISSUBJECT TO THE FOLLOWING TWO  CONDITIONS:(1)  THIS DEVICE MAY NOT CAUSE HARMFULINTERFERENCE, AND (2) THIS DEVICE MUSTACCEPT  ANY INTERFERENCE RECEIVED,INCLUDING INTERFERENCE THAT MAY CAUSEUNDESIRED OPERATION.NOTE: NO CHANGES OR MODIFICATIONS MAYBE MADE TO THE UNITS.  ANY CHANGES MADETO THE UNITS WILL VOID THE USER'S AUTHOR-ITY TO OPERATE THE EQUIPMENT.Operation1. Set the Console’s INSTALL/RUN switch to RUN.2. Press the face of the WR10A and hold for 1 second totrip the Panic Alarm. Press twice quickly to stop theAlarm.Replacing batteriesRemove the back cover and replace the battery with aCR2016 Lithium 3V battery. After replacing the battery,the following steps are necessary to determine that theConsole still recognizes the WR10A.

Navigation menu