Autostart RTR433 Remote Control Car Starter User Manual inst1200rev3

Autostart Remote Control Car Starter inst1200rev3

Contents

Revised Users Manual

Please review the installation guide beforebeginning the installation, particularly the wiringdiagram and the list of programming options.Prior to installation please be sure that all hardwarecomponents required to install theAS-1200 are in the box.This is a list of components included in theAS-1200 kit:• 1 - AS-1200 control unit• 1 - 2 button / 3 channel remote transmitter• 1 - 5 Pin 14 AWG harness (Ignition harness)• 1 - 7 Pin 18 AWG harness (Main harness)• 1 - 4 Pin / 2 Wire 18 AWG harness(Accessories)• 1 Antenna• 1 Parts Bag (hood switch, valet switch,connector, wires)• User guide, tech bulletins.NOTICE:THE MANUFACTURER IS NOTRESPONSIBLE FOR ANY RADIO OR TVINTERFERENCE CAUSED BYUNAUTHORIZED MODIFICATIONS TO THISEQUIPMENT. SUCH MODIFICATIONSCOULD VOID THE USER’S AUTHORITY TOOPERATE THE EQUIPMENT.INSTALLATION POINTS TO REMEMBER• When working on a vehicle always leave awindow open.• Remove courtesy light fuse if possible toprevent battery drain.• Never Install control unit where it couldinterfere with normal operation or obstructservice technicians.• Do not disconnect the battery on vehiclesequipped with air bags and anti-theft radios.• Always use a grommet when running wiresinto the engine compartment. Never run wiresthrough bare or sharp metal.• Always solder and tape all connections.• Never ground control unit to vehicle steeringcolumn.• Make sure that vehicles equipped withautomatic transmission do not start while inany of the drive gears. (If it will start in gearplease install a manual transmission starter)FEATURES§ Dual 12 volt power lines.§ 12 volt parking light output.§ 2 Button / 3 channel transmitter.§ Factory alarm control.§ Gasoline or Diesel engine ready.§ Positive and Negative door lock output.§ Cold weather timer.§ Negative trunk output.§ Up to 600 feet range.§ 300 milliamp ground output (pulsed orconstant)§ 300 milliamp ground when armed output.§ External trigger control (From externalreceiver. e.g.: alarm)OPTIONS• Remote keyless entry• Remote Trunk release• Engine kill• Flashing LED• Pager Ready• 3 YEAR LIMITED WARRANTYPROGRAMMABLE OPTIONS• Door lock pulse duration ( 1 sec, 4 sec, ortwo ¼ sec unlock pulses).• Ignition controlled door locks.• Constant or pulsed Groundout whenrunning.• Run time (5,15, or 25 minutes)• Maximum crank duration (6,8, or 12seconds).• Childproof operation.• Gasoline or Diesel engine operation.TRANSMITTER CODE LEARNINGAS-1200 transmitters do not come pre-programmed. They must be “CODELEARNED” at the time of installation. The unitwill hold up to 4 transmitter codes in memory.To program a new transmitter:1. Raise the hood2. Turn valet switch “off”.3. Turn ignition “on”.4. Turn valet switch “on”.Parking lights willturn on for 5 seconds.5. Press either button on transmitter within 5seconds of step 4. (lights will flash 5 timesfast, and 2 times slow)

Navigation menu