Avanti Hearth AHP289R1T Built-In Electric Fireplace On/Off Remote Control User Manual
Avanti Hearth Products Built-In Electric Fireplace On/Off Remote Control Users Manual
Users Manual
OPERATION MANUAL AHP289RIR(T)
FEATURES:
* Wireless remote control fireplace
* Remote control distance 7-10M.
* Easy wiring, installed in few minutes.
* 16 coding channels
* ON/OFF FUNCTION
* Battery low, LED FLASH,(RECE
OPERATION
Remote built-in for fireplace
INSTALLATION:
Controller(Receiver)
* Connect power to receiver(fig.1)
(Transmitter )
* Remote control till 7-10M (fig.
USAGE OF CODE SWITCH
House Code-
Allows to change to another code.
SPECIFICATIONS:
Frequency:433.92MHz
Battery: Alkaline 12V (TRANSMITTER)
Battery:AA 1.5V x 4 (RECEIVER)
CAUTION
Do not connect or use in damp places like patios, cellar, flammable liquid, solvents, paints etc....
HOUSE
CODE
AC
E
G
I
K
M
O
HOUSE
CODE
AC
E
G
I
K
M
O
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.