BRAVEN LC TUTWS Bluetooth Earbuds User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3204821
Application ID	gpOLxULhaostmN5DXYV/zw==
Document Description	user manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	7.94kB (99255 bits)
Date Submitted	2016-11-23 00:00:00
Date Available	2016-11-23 00:00:00
Creation Date	2016-11-17 11:30:56
Producing Software	Adobe PDF Library 15.0
Document Lastmod	2016-11-17 11:31:17
Document Title	user manual
Document Creator	Adobe InDesign CC 2017 (Macintosh)

TWS Earbuds
DRAHTLOSE PREMIUM-OHRHÖHRER
AURICULARES INALÁMBRICOS PREMIUM
OREILLETTES SANS FIL HAUT DE GAMME
AURICOLARI WIRELESS PREMIUM
プレミアム ワイヤレスイヤホン
高级无线耳机
РАДИОНАУШНИКИ ВЫСШЕГО КАЧЕСТВА ТИПА «КАПЛИ» (EARBUDS)
GET TO KNOW YOUR TUMI
Short Press
Long Press
TWS Earbuds
1. Power Button
Pause / play /
answer call
Power on, enter
pairing mode /
reject call
2. Micro-USB Charge Port
•
Connect Micro-USB
cable here to charge
•
Pull tab to open
TWS Earbuds
3. Removable Sport Hooks
ENG
TURN ON & BLUETOOTH PAIRING
1. Activate Bluetooth ® on the phone
or device you are pairing with (see
your device’s instruction manual
for information on activating
its Bluetooth ® settings).
2. Press and hold the Power Button
button for 5 seconds on your
TWS Earbuds
. The will turn on, and then
automatically enter pairing mode.
3. LED will flash alternating
RED and WHITE
4. Go to your phone or device’s
Bluetooth® settings and select
“ TWS Earbuds
” from the list.
5. If asked for a passcode enter “0000”
Your TWS Earbuds
will remember the last
8 devices it has paired with.
NOTE: If your TWS Earbuds
do not have an active Bluetooth®
connection and is left on, it will shut
itself off after 5 minutes. To restart your
TWS Earbuds you will need to
press and hold the Power Button for 5
seconds.
CHARGING YOUR TRUE
PLAY MUSIC
WIRELESS EARBUDS
• Before using your TWS Earbuds
for the first time,
charge the unit 7 to 9 hours.
1. Start playing music on your paired
device. Music plays through
your TWS Earbuds
• To charge your TWS Earbuds
, plug the included USB-toMicro-USB cable into a wall power
adapter (not included) or into a
powered USB port on a computer.
Plug the Micro-USB connector
end of the cable into the
2. NOTE: A tone sounds when
maximum volume setting is achieved.
TWS Earbuds charging port.
• It will take approximately 2
hours to reach a full charge.
3. Press the Power Button to
pause playback. Press again
to resume playback.
ENG
TAKING CALLS
You can listen through your
TWS Earbuds and speak
through your TWS Earbuds
microphone during phone calls.
If you make a call while paired: The
audio and microphone automatically
default to your TWS Earbuds .
• Use your phone to make the call
• Press the Power Button
to end the call
If you receive a call while paired:
Your phone rings through your
TWS Earbuds
To listen and speak through your
phone (depending on your phone),
use your phone to answer the call,
or use your phone settings to switch
to your phone during a call.
WARNINGS, CAUTIONS & LEGAL INFORMATION
To reduce the risk of fire or electric shock, do not expose the
TWS Earbuds to rain or moisture while charging. The
should not be exposed to dripping
or splashing, and objects filled with liquids, such as vases, should
not be placed on or near it while being charged or charging other
devices. As with any electronic products, use care not to spill liquids
into any part of the product. Liquids can cause a failure and/or a
fire hazard. The power supply must be used indoors only. Make
no modifications to the product or accessories. Unauthorized
alterations may compromise safety, regulatory compliance, and
system performance, and will void the warranty. Do not place any
flame sources, such as lighted candles, on or near the
parts that may be a choking hazard and is not suitable for children
under age 3. Do not continue charging the battery if it does not
reach full charge within the specified charging time. Overcharging
may cause the battery to become hot, rupture, or ignite. If you see
any heat deformation or leakage, properly dispose of the battery. Do
not attempt to charge the battery in temperatures outside the range
of 32°-104°F (0°-40°C). If the battery begins to leak, do not allow the
liquid to come in contact with your skin or eyes. If contact has been
made, wash the affected area with plenty of water and seek medical
attention immediately. Do not expose the product or battery to
excessive heat, including direct sunlight or fire and storage or use
inside cars in hot weather, where it can be exposed to temperatures
in excess of 115°F (60°C). Doing so may cause the battery and power
supply to generate heat, rupture, or ignite. Using the product in this
manner also may result in a loss of performance and a shortened life
expectancy. Extended exposure to direct sunlight may damage the
external appearance and material qualities. Do not step on, throw,
or drop batteries or the power supply or device, or expose them to
a strong shock. Do not pierce, crush, dent, or deform the batteries
or power supply in any way. If either becomes deformed, properly
dispose of it. Do not short-circuit batteries. Do not attempt to service
the TWS Earbuds yourself. Opening or removing
covers may expose you to dangerous voltages or other hazards
and will void the manufacturer’s warranty. To prevent risk of fire or
electric shock, avoid overloading wall outlets, extension cords, or
integral convenience receptacles. Your Bluetooth device (mobile
phone, music player, tablet, laptop, etc.) must support the A2DP
Bluetooth profile in order to work wirelessly with your new
. The A2DP profile is supported by most recent
TWS Earbuds
mobile products with built-in Bluetooth capability. Please refer to
your device’s user manual for details and instruction regarding the
Bluetooth profiles it supports.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:—Reorient or relocate the receiving antenna. —Increase
CAUTION: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority
to operate the equipment.
FCC RADIATION EXPOSURE STATEMENT: This device complies
with FCC radiation exposure limits set forth for an uncontrolled
environment.
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Lithium Battery installed is not intended to be replaced by the USER.
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Where the MAINS plug is used as the disconnect device, the
disconnect device shall remain readily operable.
The device meets the exemption from the routine evaluation limits
in section 2.5 of RSS 102 Issue 5 and compliance with RSS-102 RF
exposure, users can obtain Canadian information on RF exposure
and compliance.
Correct Disposal of this product. This marking indicates that
this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment
or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources.
To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased.
This product complies with California Energy Commission efficiency
standards for consumer battery chargers.
BATTERY SAFETY: Store the portable
backup battery in a cool, dry place,
and avoid exposure to moisture, high
temperatures, open flames, chemicals, or corrosive materials. Do
not short circuit, open, disassemble, modify, repair, or replace
any part of the portable backup battery. Doing so may cause the
battery to ignite, explode, leak, or become excessively hot, causing
personal injury. Avoid excessive impact, physical shock, or vibration
as they may damage the portable backup battery. Inspect the
case carefully before each use, especially after any drop, bump or
other impact, to identify any sign of damage. If the portable backup
battery becomes damaged, swells, leaks, overheats, or functions
abnormally, immediately discontinue use and contact Incipio.
Avoid all contact with contents from a leaking battery. The portable
backup battery is designed to be charged many times. Use the
included micro USB cable and an approved battery charger. Never
use a modified or damaged battery charger. Do not reverse charge
or reverse connect the battery. Please note the battery will normally
be warm during charging. Recycle or dispose of the portable backup
battery’s batteries properly and in accordance with applicable
federal, state and local laws and regulations. Do not dispose of
batteries in the trash or fire.
ENG
the separation between the equipment and receiver. —
­ Connect
the equipment into an outlet on a circuit different from that to which
the receiver is connected. — Consult the dealer or an experienced
radio/TV technician for help.
TUMI’S ACCESSORIES WARRANTY
Since our founding in 1975, Tumi has been committed
to providing our customers with an ownership
experience that is second to none. Specifically, we
make three promises to our customers:
1. You will enjoy using innovative products that
are designed and manufactured to be the best;
2. You will experience world-class customer
service for as long as you own your product;
3. For two (2) years after you purchase Tumi
small leather goods or accessories, virtually
any problem that you encounter with the
product will be covered by our warranty.
Tumi’s warranty is just a small part of the ownership
experience that we provide to our customers, and you
will find that it is straightforward and comprehensive.
FIRST YEAR OF OWNERSHIP: 		
TOTALLY WORRY FREE
For the first twelve (12) months of ownership, if any
damage – including wear and tear – happens to your
Tumi product, Tumi will cover all repair expenses,
including shipping costs to and from our repair facility.
The only exceptions to this are purely cosmetic
damage, such as scratched leather, and incidents or
consequential damages, such as damage to, or loss
of, the contents of a bag, loss of use, loss of time or
similar expenses.
YEAR TWO: FULL COVERAGE
Through your second year of ownership, Tumi will
cover all of the repair costs for any problems that
result from defective materials or workmanship or
damage from wear and tear. The only exceptions to
this are damages caused by obvious abuse of the
product, purely cosmetic damage and incidental or
consequential damages as described above. Your
only responsibility is to ship your item to us for repair,
or take it to a Tumi store or authorized Tumi dealer,
who will be happy to process the repair for a nominal
handling and shipping fee. Many repairs can actually
be handled right in the store, but if your item does
need to be sent to our facility, we will repair it quickly
and ship it back at no cost to you. In those rare cases
mentioned above where our warranty does not apply,
we will promptly provide you with an estimate of any
repair costs that may be involved.
ENG
A LIFETIME OF SERVICE
It is extremely rare that we see an accessory product
problem due to a manufacturing defect show up after
two years of use, but we do have many customers
with older items that they would like to have
refurbished. For these customers, we offer a lifetime
of courteous, responsive service and the highest
quality repairs and refurbishment done at the lowest
possible cost.
TOTAL COMMITMENT
The bottom line is that at Tumi, we are totally
committed to keeping you happy about our products
and our service. Once you have had the pleasure of
owning and using our products, we hope that they
will become your trusted companions for life. You
can reach us online, 24 hours a day, 7 days a week at
www.tumi.com/repair or call 800.781.TUMI (8864) to
speak with a customer service representative during
normal business hours. (To contact customer service
outside of the US and Canada, please see the list of
international centers that follows.)
PROOF OF PURCHASE
Please save your store receipt as proof of purchase.
This will be needed to facilitate your first year worryfree coverage. Additionally, this will serve as proof
that your purchase was made at an authorized Tumi
retailer. Our warranty services only apply to products
that were purchased from an authorized Tumi store
or dealer.
CUSTOMER SERVICE CONTACT NUMBERS
USA/Canada
800.781.8864
For additional locations, please refer to tumi.com
TUMI
1001 Durham Avenue
South Plainfield, NJ 07080

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
XMP Toolkit                     : 3.1-701
Modify Date                     : 2016:11:17 11:31:17+08:00
Create Date                     : 2016:11:17 11:30:56+08:00
Metadata Date                   : 2016:11:17 11:31:17+08:00
Creator Tool                    : Adobe InDesign CC 2017 (Macintosh)
Format                          : application/pdf
Document ID                     : uuid:7e37b3f3-781e-4a63-889d-a984f0614261
Instance ID                     : uuid:a64b4fd7-a481-493f-9578-e85d3d7a4190
Producer                        : Adobe PDF Library 15.0
Page Count                      : 9
Creator                         : Adobe InDesign CC 2017 (Macintosh)

EXIF Metadata provided by EXIF.tools