Balboa Instruments SPASIDE1 SPA Monitor Transceiver User Manual Spa Monitor Manual indd

Download:
Mirror Download [FCC.gov]
Document ID	440570
Application ID	FYEoaaVil9DXwRS+PwAIJA==
Document Description	Exhibit D Users Manual per 2 1033 b3
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	305.8kB (3822512 bits)
Date Submitted	2004-06-15 00:00:00
Date Available	2004-06-15 00:00:00
Creation Date	2004-06-03 11:13:31
Producing Software	Adobe PDF Library 6.0
Document Lastmod	2004-06-03 12:03:55
Document Title	Spa_Monitor_Manual.indd
Document Creator	Adobe InDesign CS (3.0.1)

BALBOA SPAMONITOR
O p eratin g Instr uc tions
TABLE OF CONTENTS
Button Call Outs .................................................................................................................................. 3
Mode Operation .................................................................................................................................. 4
Sync/Jets Operation ............................................................................................................................ 4
Diagnostic Messages .......................................................................................................................... 5
ML900 Message Cross-Reference Table for Diagnostic Messages ...................................................6-7
ML900 Message Cross-Reference Table for Reminder Messages ...................................................... 7
Sounds................................................................................................................................................ 8
Things to Avoid .................................................................................................................................... 8
IMPORTANT:
The user is cautioned that changes not expressly approved by Balboa Instruments, Inc. could void the
user’s authority to operate the equipment.
Page 2
Battery Low
Heat On
Light On
Jets On
SYNC/JETS
CAUTION:
Pull carefully
with your
fingernail
from the top
right corner to
open.
Page 3
UP
LIGHT
DOWN
MODE
Mode
This button is used to switch between standard, economy, and sleep modes. Press MODE to enter mode
programming, press “Down” to cycle through to desired mode (LCD flashes until confirmed), then press
MODE to confirm selection.
Standard mode maintains the desired temperature. Note that the last measured spa temperature displayed is
current only when the pump has been running for at least 2 minutes. “Std” will appear on the display momentarily
when you switch into Standard Mode.
Economy mode heats the spa to the set temperature only during filter cycles. “Ecn” will appear solid when the
temperature is not current and will alternate with the temperature when the temperature is current.
Pressing SYNC/JETS while in Economy mode puts the spa in Standard-In-Economy mode, (“SE”) which
operates the same as Standard Mode, then reverts to Economy Mode automatically after 1 hour. Press DOWN or
UP followed by LIGHT to revert the mode to Economy immediately.
Sleep mode heats the spa to within 20°F (11°C) of the set temperature only during filter cycles. “SLP” will appear
on the display until mode is changed.
Sync/Jets
The SYNC/JETS button on the SpaMonitor works like the JETS1 button on your main panel (or like the
JETS button if your main panel has only one Jets button).
Page 4
Diagnostic Messages
Message
Meaning
Action Required
The spa is operating in Standard Mode.
Temperature display is current after pump has been
running for at least 2 minutes.
The spa is operating in Economy Mode.
“Ecn” will appear solid on the display when the
temperature is not current. “Ecn” will alternate with the
temperature when the temperature is current.
The spa is operating Standard-in-Economy
Mode.
Operates the same as Standard mode, then reverts to
Economy mode after 1 hour. Press MODE to switch
directly to Economy mode.
Sleep Mode has been activated by pressing
a button combination on the user panel.
“SLP” will appear solid on the display when the
temperature is not current. “SLP” will alternate with the
temperature when the temperature is current.
The spa is operating in Test Mode.
The Spa Monitor is unable to operate
normally in Test Mode.
Contact your distributor or authorized dealer to have the
spa switched back to User Mode.
Consult your main panel documentation for the meaning and required action that corresponds to any additional
three-letter diagnostic or reminder messages that may appear on the SpaMonitor display. If you use an ML900 main
panel, consult the ML900 Cross-Reference Table on the next page to correlate the three-character message on the
SpaMonitor with the 12-character message on the ML900.
Page 5
ML900 Message Cross-Reference Table
Diagnostic Messages
SpaMonitor
ML900
SpaMonitor
Page 6
ML900
ML900 Message Cross-Reference Table
Diagnostic Messages (Continued)
SpaMonitor
ML900
SpaMonitor
ML900
alone
alternating with temperature
Reminder Messages
SpaMonitor
ML900
SpaMonitor
Page 7
ML900
Sounds
The Spa Monitor sounds an alarm when it detects the spa offline for more than 3 hours* or when the spa detects a
condition that may require your attention (i.e. overheat). Press any button to reset the alarm.
*The SpaMonitor detects the spa offline when it cannot communicate with the base unit. This can occur when the
Spa Monitor is out of range or if there is a connection or power problem.
Things to Avoid
Be careful not to press multiple buttons together in normal use. Certain combinations of buttons put the
SpaMonitor into special modes which are covered in the Installation Manual.
Page 8

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Count                      : 8
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:c2941bc0-b590-11d8-a644-003065c4d734
Create Date                     : 2004:06:03 11:13:31Z
Metadata Date                   : 2004:06:03 12:03:55-07:00
Modify Date                     : 2004:06:03 12:03:55-07:00
Creator Tool                    : Adobe InDesign CS (3.0.1)
Rendition Class                 : proof:pdf
Document ID                     : adobe:docid:indd:1ecc3406-b6dc-11d8-8500-d7d7dd7ded9d
Derived From Instance ID        : 1ecc3405-b6dc-11d8-8500-d7d7dd7ded9d
Derived From Document ID        : adobe:docid:indd:3d7dbfe4-b6ce-11d8-8500-d7d7dd7ded9d
Format                          : application/pdf
Title                           : Spa_Monitor_Manual.indd
Trapped                         : False
Creator                         : Adobe InDesign CS (3.0.1)
Producer                        : Adobe PDF Library 6.0

EXIF Metadata provided by EXIF.tools