Baxi Solo 2 Rs Owners Manual 232187

: Baxi Baxi-Solo-2-Rs-Owners-Manual-106933 baxi-solo-2-rs-owners-manual-106933 baxi pdf

Open the PDF directly: View PDF .
Page Count: 4

Download
Open PDF In Browser	View PDF

Please keep these Instructions safe.
Should you move house, please hand
them over to the next occupier.

Baxi Solo 2 RS Range
Wall Mounted Room Sealed
Gas Fired Central Heating Boilers

User’s Operating
Instructions

Natural Gas

Your Baxi Solo is a gas fired, room sealed central heating boiler providing
heating for your home and domestic hot water where required.

Baxi Solo 2 60 RS
G.C.No. 41 077 79
Baxi Solo 2 50 RS
G.C.No. 41 077 78

OPERATING YOUR SOLO
1

Baxi Solo 2 40 RS
G.C.No. 41 077 77

1

Baxi Solo 2 30 RS
G.C.No. 41 077 76

2

3

Remove lower door panel as
shown.

Turn the boiler thermostat knob
2
to the '0' position fully anticlockwise.
Turn on the main gas and
3
electricity supplies to the
appliance.

IGNITER BUTTON

light the pilot: Looking
4pressTo
through the pilot viewing window
the gas control knob fully
inwards and hold. Press in igniter
button and release. Repeat until
pilot ignites. Continue to hold in
gas control knob for
approximately 15 seconds
and then release. Pilot should
stay alight.

GAS CONTROL
KNOB

NOTE: If pilot fails to remain alight or
is extinguished at any time, wait at
least 3 minutes then repeat the
procedure from the start of section "4".
Once the pilot is alight it may be left
on permanently.

Baxi Limited is one of the leading
manufacturers of domestic heating products in
the UK.

5

To light the boiler: Ensure that
all external controls, e.g. room
thermostat, timer, etc. are calling for
heat. Turn boiler thermostat fully
clockwise to high setting. Main burner
will then light.

Our first priority is to give a high quality service
to our customers. Quality is built into every
Baxi product - products which fulfil the
demands and needs of customers, offering
choice, efficiency and reliability.

To keep ahead of changing trends, we have
made a commitment to develop new ideas

BOILER THERMOSTAT KNOB

It is recommended that the boiler
thermostat is used on HIGH setting
in winter and a minimum of no 2 in
summer to ensure adequate
domestic hot water.

using the latest technology - with the aim of
continuing to make the products that
customers want to buy.

Everyone who works at Baxi has a
commitment to quality because we know that
satisfied customers mean continued success.

We hope you get a satisfactory service from
Baxi. If not, please let us know.

“Benchmark” Installation, Commissioning and
Service Record Log Book
Please ensure that your Installer has completed
the Installation and Commissioning sections of
the Log Book, and hands the Log Book over. The
details of the Log Book will be required in the
event of any warranty work. Keep the Log Book in
a safe place and ensure that the relevant sections
are completed at each subsequent regular
service visit.

Baxi is a BS-EN ISO 9001
Accredited Company
page 2

OVERHEAT CUT-OFF DEVICE

TO SHUT DOWN THE BOILER

1

Your boiler is fitted with an additional
safety device which shuts down the
appliance should the system
overheat. If the pilot is extinguished
for no apparent reason and cannot
be re-ignited, this overheat cut-off
device may have operated.

Turn off the electricity supply to
the appliance at the mains.

To turn off the pilot: Turn gas
2
control knob to off position
marked 0.

NOTE: Any interruption to the
electricity supply may cause the
device to operate. In the case of
persistent operation of the device,
turn off the boiler and consult your
service engineer as an appliance or
system fault is indicated.
If the boiler wiring has been altered
to allow gravity domestic hot water
operation, the overheat thermostat
will be inoperable.
NOTE: The gas control knob cannot
be depressed until ignition restart
interlock device in gas valve has
disengaged. This takes 60 seconds
approximately.

RESETTING
To reset the device follow these
instructions.

3

Turn off the gas supply at
either the appliance gas cock
or the meter.

Allow the boiler to cool if hot.
Remove the lower door panel by
following the instructions on the
opposite page.

If your home is to be left unoccupied
for long periods during cold weather,
the whole system should be drained,
unless a frost-stat is fitted. Your
installer will advise you about
draining the system.

Locate the red/brown reset button
adjacent to the boiler thermostat
knob. Press the button
to reset the overheat
thermostat.

NOTE: Depending on the design of
your central heating system, the
pump may keep running for
approximately 3 minutes after any
external controls e.g. timer,
programmer have turned the
appliance off. This is perfectly normal
and is because your Solo 2 RS is
fitted with a timed pump overrun to
prevent overheating.

Re-ignite the boiler
by
following
the
instructions on the opposite page.

Warnings
IN CASE OF GAS LEAKS

THIS APPLIANCE MUST BE EARTHED

If a gas leak is found or suspected, turn off the
gas supply at the meter immediately and contact
your Installer or Transco (under 'Gas' in the phone
directory).

Electricity supply:
A standard 230 volt ~ 50Hz supply is required. The
appliance must be protected by a 3 amp fuse.

NEVER HANG CLOTHES OR OTHER
ITEMS OVER THE APPLIANCE.
SERVICING YOUR BOILER
We strongly recommend that your Boiler is serviced
annually for reasons of safety and economy. Your
Installer or British Gas Service will be able to advise
you.

SAFE INSTALLATION
Installation of this appliance must be carried out by
a CORGI Registered Installer and be in accordance
with the relevant requirements of the current GAS
SAFETY (Installation and Use) REGULATIONS and
any other regulations applying in your area.

page 3

CLEARANCES AROUND THE BOILER

CLEANING THE CASE
The painted panels should be wiped
with a damp cloth and then dried
completely.
DO
NOT
USE
ABRASIVE CLEANING AGENTS.

The minimum clear spaces needed
around the boiler are:
Top:
(For Pumped)
(For Gravity)

50mm (2 in)
80mm (31/8 in)

Bottom:
Sides:
Front:

50mm (2 in)
5mm (3/16 in)
5mm (3/16 in)

SPARE PARTS
Any repairs to the appliance will
usually be the responsibility of the
Installer during the guarantee period
after which spare parts may be
obtained through approved Baxi
stockists if required. Quote the
appliance name, model number and
where possible the part number
when ordering spares. (A parts list is
included in the Installation and
Servicing Instuctions.)

These clearances must not be
obstructed in any way. Blocking
the clearance spaces will result in
the appliance overheating and
possible damage may occur.
5
420

The gas burning compartment of
your boiler is completely sealed
from the room in which it is fitted.
Products from the combustion of
gas are vented to the outside
through the flue terminal which
must be kept free from obstruction
as this would interfere with the
correct operation of the boiler.
If the boiler is fitted in a
compartment, this should be fitted
with ventilation openings at high
and low level which must not be
blocked. Occasional checks
should be made to ensure they are
clear. The compartment should be
large enough to house the boiler
and ancillary equipment only.
IT SHOULD NOT BE USED AS A
STORAGE CUPBOARD.

5

50
80
Gravity

300

600

50

300mm is required for servicing.
5mm is required when operating.

GUARANTEE
Your BAXI SOLO 2 is designed and produced to
meet all the relevant British Standards.

To maximise the benefit from our guarantee we urge
you to return the reply-paid guarantee registration.

Baxi Limited provide a 12 month guarantee on the
Boiler - other parts of the system are covered by the
Installer or other manufacturers. The guarantee
operates from the date installation is completed for
the customer who is the original user.

This does not in any way prejudice your rights at
Common Law. Such rights between the customer
and the installer or supplier from whom the unit was
purchased remain intact.

Any component or part which becomes defective
during the guarantee period as a result of faulty
workmanship or material whilst in normal use will be
repaired or replaced free of charge.

Comp No 232187 - Iss 7 - 12/00
Baxi UK Limited
Brownedge Road Bamber Bridge Preston Lancashire England PR5 6SN
After Sales Service 08706 096 096 Technical Enquires 08706 049 049



---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : Yes
Create Date                     : 2001:07:27 10:56:09
Producer                        : Acrobat Distiller 4.0 for Macintosh
Author                          : Tex HD
Title                           : 232187
Creator                         : QuarkXPress(tm) 4.1
Modify Date                     : 2001:07:27 10:56:38Z
Page Count                      : 4

EXIF Metadata provided by EXIF.tools