Behavior Tech Computer KB5301 Keyboard User Manual 8
Behavior Tech Computer Corporation Keyboard 8
8
EXHIBIT 7 USER’S MANUAL OF EUT 5301 KEYBOARD USER'S GUlDE Fearures ‘. The keyboards are fully compaflbl e with lBM AT and PS/2. KEYBOARD CABLE CONNECTOR AT Compatible Cable (S-pin Din Cunneclor) Pink Signal Name Vullage 1 Keyboard Clock +5vnc Signal 1 Ground 0 3 Keyboard Dam +5voc Signal 4 Power Supply +5vnc a No Cnnncclion PS!2 Compatible Cable 16»pin Minimums Din Conneclor) pruu Signal Name Voltage 1 mm“: (”luck esvpc Signal 2 Grnund o 3 mmm Dam 6ch Srgnal 4 Reserved 0 5 +svnc +5voc 6 Reserved 0 TECHNlCAL DATA Power Requirement +5 VDC @l00 mA nominal Environment Data Operaling temperature Relative humidily Allilude Mechanical Data Total Travel Preu'avel Peak Lead before Make (normal key) JIM / Al mm M" 1 “w rugml’n’d lnulumm-kx p) Ammmnmml [I : (PC to 50°C : 7.0% to 90% non-cundensing : l000 ft (0 l0000 fl ,3.5t0.5 mm : 10t0.5 mm '. 55t20 grams 1mm Mu‘lmnfl ( Mywmmm FCC GUIDELINES This equipment has been tested and found to compiy with the limits for a Class B digital device, pursuant to Part is of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates. uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur in a particular installation if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user IS encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna . Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help. ‘ Use only shielded cables to connect l/O devices to this equipment. Information to User: Of Any changes or modifications nut expressly approved by the party responsible fur compliance could void the user‘s authority in operate this equipment. Shielded interface cable. Utmy, must be used in order to comply with emission limits: JIODSDBNO Version 1 l September 1992 aned in China
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.2 Linearized : Yes Create Date : 2001:05:21 08:53:56 Producer : Acrobat Distiller 4.0 for Windows Modify Date : 2001:05:21 08:53:57-04:00 Page Count : 3EXIF Metadata provided by EXIF.tools