Behavior Tech Computer KB6311ARF3 Wireless Keyboard User Manual Quick Installation Guide
Behavior Tech Computer Corporation Wireless Keyboard Quick Installation Guide
User manual
Quick Installation Guide (English)
1. Make sure the batteries of the keyboard is installed correctly. Please follow the polarity
signs in the battery compartment.
2. Please make sure the slide switch on the back of the Keyboard is switched to “on”
before using the ketboard. When not in use, please turn the power switch to “off” for
power saving.
3. Plug the receiver directly into your available USB port on PC.
Change the cursor pointer speed
You can modify the mouse pointer speed settings in the control panel.
1. Open the Start Menu by clicking “Start” at the lower-left corner on the screen
2. Then click on Settings / Control Panel / keyboard
3. In the Keyboard Properties window that appears, click the Motion tab
4. Move the slide bar toward either the faster end or the slower end
5. Click OK to exit and make the change effective
Pairing Procedure
It can operate out of the box immediately after you plug the receiver USB connector into
your PC USB port. If it can’t work, please visit our website to download and install the
“Pairing Tool.”
System Requirements
Available USB port
Microsoft® Internet Explorer 6.0 or later version (for the Internet keys)
Microsoft® Windows® 7, Windows® XP or Windows Vista® operating system
The system supports ACPI or APM II (for power management buttons)
ATX mother board and ATX power supply (for power management buttons)
Requisiti del sistema
Wireless Keyboard / 6311ARF III / EMPREX,BTC
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the installation. , May cause harmful interference to
radio communication. However, there is no guarantee that interference
Will not occur in a particular installation. if this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna
-Increase the separation between the equipment and receiver
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
-Consult the dealer or an experienced radio / TV technician for help
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
FCC RF radiation exposure statement:
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.