Behavior Tech Computer KB9110 Keyboard User Manual 9110e1
Behavior Tech Computer Corporation Keyboard 9110e1
Exhibit 7 The user manual of EUT
9110 KEYBOARD USER'S GUIDE This keyboard is fully compatible with IBM AT and PS/2. Keyboard Cable Connector AT Compatible Cable (5-pin Din Connector) Pin# Signal Name Keyboard Clock Ground Keyboard Data Power Supply No Connection Voltage +5VDC Signal +5VDC Signal +5VDC PS/2 Compatible Cable (6-pin Miniatures Din Connector) Pin# Signal Name Keyboard Clock Ground Keyboard Data Reserved +5VDC Reserved Voltage +5VDC Signal +5VDC Signal +5VDC The ACPI Power Management Keys and Their Functions System requirement: Ø Ø Ø Microsoft Windows 98 operating system. The system supporting ACPI or APMII. ATX motherboard and ATX power supply. The functions of the power management are specified and performed by Windows 98 operating system, no vendor-specified driver is needed to use them, but the Windows 98 operating system is necessary. There could be one or two or three ACPI power management keys on the keyboard, those functions are as follows. Power off key: Power down the system. Sleep key: Put the system to sleep. Wake up key: Wake up or powers up the system. Power key: (Single key with three functions above) Ø Press this key and hold over four seconds to power down the system. Ø Press this key and release it within four seconds to put the system to sleep. Ø When the system is asleep or powered down, press this key and release it within four seconds to wake up or power up the system. FCC GUIDELINES This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ♦ Reorient or relocate the receiving antenna ♦ Increase the separation between the equipment and receiver ♦ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ♦ Consult the dealer or an experienced radio/TV technician for help. ♦ Use only shielded cables to connect I/O devices to this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Information to User: F Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Shielded interface cable, if any, must be used in order to comply with emission limits. IBM AT and PS/2 are registered trademarks of International Business Machines Corporation. Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States and/or other countries. All other trademarks are trademarks of their respective holders. 3100504464 Version 1.0 November 1999 Printed in China
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.2 Linearized : No Page Count : 2 Creator : .穨.Microsoft Word Create Date : 1999:12:27 11:38:26 Title : .穨.9110e1.PDF Author : .穨.Ariel Producer : Acrobat PDFWriter 4.0 for WindowsEXIF Metadata provided by EXIF.tools