Belkin AV4 User Manual To The Decf4c43 224f 4574 Bc9f 4b51137a3d8c

User Manual: Belkin AV4 to the manual

Open the PDF directly: View PDF .
Page Count: 2

1 2 43

Connect transmitter to video source

and to power. Connect IR emitter

cable. Turn on video source.

Route IR emitter cable

end to the front of your

video source.

Using the included IR emitter, ScreenCast can

relay signals from your remote control to your

video source. You will aim this in step 3.

Connect receiver to TV

and to power. Make sure

receiver’s top surface is

visible in order to receive

signals from your remotes.

Use the source’s remote at

close range to find where

IR signals are received.

Then aim the end of the

IR emitter at that spot.

turn

HDMI

IR

HDMI

SCREENCAST AV 4

SCREENCAST AV 4

TV INPUT: HDMI

INPUT

OK

OK

5 6

Use your TV remote to set the input

to the HDMI port that the ScreenCast

receiver is connected to.

Remove the battery tab from the

ScreenCast remote and use it to

complete the on-screen setup.

Optional wall-mounting of receiver: Use the included

wall-mounting template and hardware to mount the

receiver to the wall. Make sure that at least the front half

of the top surface is visible, so that it can receive signals

from your remotes.

© 2011 Belkin International, Inc. All rights reserved. All trade names

are registered trademarks of respective manufacturers listed.

F7D4515 • 8820-00862 Rev. A03