Belkin F7U027 Boostup Wireless Charging Pad User Manual Statement

Belkin International, Inc. Boostup Wireless Charging Pad Statement

Contents

User Manual Statement

Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Radiation Exposure Statement:
The product comply with the FCC/IC RF Exposure for Low Power Consumer
Wireless Power Transfer. RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual.
The further RF exposure that compliance was demonstrated at 10cm and
greater separation from the user body or set the device to lower output power
if such function is available.
Industry Canada statement
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) le
dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit
accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un
fonctionnement indésirable.
Radiation Exposure Statement:
The product comply with the IC RF Exposure for Low Power Consumer Wireless
Power Transfer. RF exposure limit set forth for an uncontrolled environment and are
safe for intended operation as described in this manual. The further RF exposure that
compliance was demonstrated at 10cm and greater separation from the user body or
set the device to lower output power if such function is available.
Déclaration d'exposition aux radiations:
Le produit est conforme à l'exposition RF IC pour le transfert de puissance sans fil de
consommateurs de faible puissance. La limite d'exposition RF fixée pour un
environnement non contrôlé est sans danger pour le fonctionnement prévu tel que
décrit dans ce manuel. L'exposition RF supplémentaire que la conformité a été
démontrée à 10 cm et plus de séparation du corps de l'utilisateur ou de mettre
l'appareil à la puissance de sortie inférieure si une telle fonction est disponible.

Navigation menu