Benq H0523 Tri-Mode Dual-Band Analog/PCS Phone (AMPS/CDMA) User Manual
Benq Corporation Tri-Mode Dual-Band Analog/PCS Phone (AMPS/CDMA) Users Manual
Benq >
Users Manual
Body-worn Operation This device was tested for typical body-worn operations with the back of the phone kept 0.6 inches (I.5cm) from the body. To comply with FCC RF exposure requirements, a minimum separation distance of 0.6 inches (I.5cm) must be maintained between the user's body and the back of the phone, including the antenna, whether extended or retracted. Third-party belt-clips, holsters and similar accessories containing metallic components shall not be used. Body-worn accessories that cannot maintain 0.6 inch (I.5cm) separation distance between the user's body and the back of the phone, and have not been tested for typical body-worn operations may not comply with FCC RF exposure limits and should be avoided. Use only the supplied or an approved replacement antenna. Unauthorized antennas, modifications, o r attachments could damage the phone and may violate FCC regulations. NORMAL POSITION: Hold the phone as you would any other telephone with the antenna pointed up and over your shoulder. TIPS ON EFFICIENT OPERATION: For your phone t o operate most efficiently: Extend your antenna fully. Do not touch the antenna unnecessarily when the phone is in use. Contact with the antenna affects call quality and may cause the phone to operate at a higher power level than otherwise needed. For more information about RF exposure, please visit the FCC website at www.fcc.gov Your wireless handheld portable telephone is a low power radio transmitter and receiver. When it is ON, it receives and also sends out radio frequency (RF) signals. Check the laws and regulations on the use of wireless telephones in the areas where you drive. Always obey them. Also, if using your phone while driving, please: Give full attention to driving - driving safely is your first responsibility; Use hands-free operation, if available; Pull off the road and park before making or answering a call if driving conditions so require. In August, 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless phones. Those guidelines are consistent with the safety standards previously set by both U.S. and international standards bodies: ANSIC95. I (I992)' NCRP Report 86 (I986) ICIMIRP( 1996) Most modern electronic equipment is shielded from RF signals. However, certain electronic equipment may not be shielded against the RF signals from your wireless phone. Those standards were based on comprehensive and periodic evaluations of the relevant scientific literature. For example, over I20 scientists, engineers, and physicians from universities, government health agencies, and industry reviewed the available body of research t o develop the ANSI Standard (C95. I). Nevertheless, we recommend that you use a handsfree kit with your phone (such as an earpiece or headset) t o avoid potential exposure t o RF energy. The design of your phone complies with the FCC guidelines (and those standards). Pacemakers The Health Industry Manufacturers Association recommends that a minimum separation of six (6") inches be maintained between a handheld wireless phone and a pacemaker t o avoid potential interference with the pacemaker. These recommendations are consistent with the
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Modify Date : 2002:06:27 16:42:45-03:00 Create Date : 2002:06:27 16:39:49-03:00 Creator : Acrobat 5.0 Paper Capture Plug-in for Windows Page Count : 41 Mod Date : 2002:06:27 16:42:45-03:00 Creation Date : 2002:06:27 16:39:49-03:00 Producer : Acrobat 5.0 Scan Plug-in for Windows Metadata Date : 2002:06:27 16:42:45-03:00EXIF Metadata provided by EXIF.tools