Benro Image Technology R1 REDDOG User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3886350
Application ID	rVElfqpX8osLnCMk6LPmkw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	99.64kB (1245512 bits)
Date Submitted	2018-06-13 00:00:00
Date Available	2018-06-13 00:00:00
Creation Date	2018-06-07 21:46:40
Producing Software	Adobe Acrobat 7.0 Image Conversion Plug-in
Document Lastmod	2018-06-07 21:47:55
Document Title	User Manual
Document Creator	Adobe Acrobat 7.0

R1 REDDOG
Camera Installation
pl
ount the camera in parallel with the mounting
ate, match the 1/4’Threaded Hole at the
bottom of the camera with the empty slot on
the mounting plate.
Ti
Tl
ove the camera as close as possible to the
It Motor.
ghten the camera mounting screw to set the
camera position.
Balance Adjustment
Follow the instructions below (1—4), adjust the
camera position until all 3 axes are balanced.
Change Handle Mode
0 change the handle mode, loosen the handle
screw, hold the handle and pan axis firmly,
rotate the handle, and finally tighten the
andle screw
Battery Installation
Insert the two batteries in the correct polarity
osition.
Don’t mix with other batteries, otherwise it
will damage the batteries and stabilizer.
Camera control cable
he cable is used to connect the controller to
the camera, it does not support hotswapping.
0 remove the cable, please first shut off the
camera.
tllll III
Control panel
ntroduction
Joysfick
Indicator OlvtMocleI/OFF
Zooming RECOI‘dmg
Shufier
CAUTION: ON(MOde)/OFF — Slide down to turn
n, Continue slide down to switch modes
Quick Storage
Balance and calibration only has to be done
nce for your camera. Once initial setup has
een performed on your Kylin you can simply
remove your camera from the device when not
(I
sing the stabilizer. If you want to resume use
imply remount your camera and turn the
evice on (you do not need to rebalance for
the same camera).
Product Specification
To active Bluetooth, slide down and hold the
l3
ower button for 5 seconds until the blue indi—
ator starts blinking.
f(_(_ lNrURMAIlUN
Note: This equipment has been tested and found to comply with the
limits for a Class 8 digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception. which can be determined by turning the equiprrent off and
on, the user is encouraged to try to correct the interference by one or
more of thefollowing measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
this device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful Interference, and (2) thls device
must accept any interference received, including interference that may
cause undesired operation.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
XMP Toolkit                     : 3.1-701
Modify Date                     : 2018:06:07 21:47:55+08:00
Create Date                     : 2018:06:07 21:46:40+08:00
Metadata Date                   : 2018:06:07 21:47:55+08:00
Creator Tool                    : Adobe Acrobat 7.0
Format                          : application/pdf
Document ID                     : uuid:8c5f1510-3ad5-4625-9641-8bd8609bf9bc
Instance ID                     : uuid:cf987ce4-c026-4d4e-8f69-3dfe1c7788ca
Producer                        : Adobe Acrobat 7.0 Image Conversion Plug-in
Page Count                      : 1
Creator                         : Adobe Acrobat 7.0

EXIF Metadata provided by EXIF.tools